Abstract:This paper presents a laboratory study on electrokinetic dewatering (EKD) of sewage sludge with fixed and moving electrodes. The experiments with fixed electrodes were conducted in two purposely designed Perspex cylinders to investigate the mechanism of attenuation in electroosmotic flow and dewatering efficiency. The experiments with moving electrodes were performed in an innovatively designed apparatus, in which the anode made of an array of stainless rods can be moved toward the fixed cathode plate. The fixed-electrode experiments showed that the electrical resistance of the dewatered section near the anode increased with the treating time, and hence the voltage gradient left for the undewatered section decreased. The increased electrical resistance resulted in an increase in the invalid energy consumption, and the reduced voltage gradient at the undewatered section resulted in an attenuation in electroosmotic flow and dewatering effect. Comparison tests conducted with the moving-anode apparatus further demonstrated the attenuation mechanism. Only a slight attenuation in the electroosmotic flow was observed in the moving-anode experiments, in which the anode array was moved to pass by the dewatered section and keep the voltage gradient on the undewatered section unchanged. As compared with the fixed-electrode experiments, the dewatering effect for the moving-anode experiments was much better, and the energy consumption in terms of removed water volume was significantly lower. When the moving-anode method was applied with a voltage gradient of 8 V/cm and an initial electrode spacing of 1 cm, the sludge with a water content of 82.1% can be dewatered to 62.2%, and the estimated energy consumption is as low as 18 kWh . m(-3). The research findings shine a light on the use of the moving-electrode method for improving the treatment efficiency of EKD. (C) 2015 American Society of Civil Engineers.

Relationship Between the Equivalent Model of Electrobath in Wastewater Treatment and Arrangement of the Electrodes

Modeling And Analysis Methods For The Dwpt System Applicated In Evs Charging

Electro-osmotic Permeability Model Based on Ions Migration

Load Characteristics of Dye Wastewater Purified by Electrocoagulation With Pulsed Power Supply

Experimental research on influence of cracks on size effect of electro-osmosis model

Electrokinetic Dewatering of Sewage Sludge with Fixed and Moving Electrodes: Attenuation Mechanism and Improvement Approach

Experimental Research on Effect of Electrode Spacing on Electro-Osmotic Dewatering under Same Voltage Gradient

Experimental Research on Influence of Electrode Array on Electroosmotic Effect

Experimental Research on Effect of Applied Voltage on One-Dimensional Electroosmotic Drainage

Analysis of bilateral electro-osmotic method with triethylenetetramine inhibitor

Analysis on Electric Double Layer of Dye Wastewater Purified by Electrocoagulation With Pulsed Power Supply

Analytical Model and Experiment for Electro-Kinetic Remediation of Contaminated Soil Considering Thermal Diffusion

Investigation on the electrolysis voltage of electrocoagulation

Comparison of Electrochemical Chloride Extraction Models for Reinforced Concrete Structures Based on Multiple Potential Theories

Effect of Electric Potential Condition on Numerical Simulation of Electrochemical Rehabilitation for Concrete Structures

STUDY ON OPTIMIZATION OF PARAMETERS OF ELECTRO-OSMOSIS ELECTRODES

Equivalent circuit model for electrosorption with redox active materials

Performance Analysis of Alkaline Water Electrolysis System Based on Heat Current Modeling Method

Analysis of the Kinetics of Electrochemical Migration on Printed Circuit Boards Using Nernst-Planck Transport Equation

Effects of electrodialysis conditions on waste acid reclamation: Modelling and validation

Electro-osmotic Treatment of Dredged Sediment by Different Power Supply Modes: Energy Consumption and Electro-osmotic Transport Volume