Abstract:This paper presents a novel interleaved soft-switching bidirectional snubberless current-fed full-bridge voltage doubler (dc/dc converter) for an energy storage system in fuel cell electric vehicles. A novel secondary modulation technique is also proposed to clamp the voltage across the primary-side switches naturally with zero-current commutation. It, therefore, eliminates the necessity for an external active-clamped circuit or passive snubbers to absorb the switch turn-off voltage spike, a major challenge in current-fed converters. Zero-current switching of primary-side devices and zero-voltage switching of secondary-side devices are achieved, which significantly reduce switching losses. An interleaved design is adopted over a single cell to increase the power handling capacity obtaining merits of lower input current ripple, reduction of passive components' size, reduced device voltage and current ratings, reduced conduction losses due to current sharing, and better thermal distribution. Primary device voltage is clamped at rather low-reflected output voltage, which enables the use of low-voltage semiconductor devices having low on-state resistance. Considering input current is shared between interleaved cells, conduction loss of the primary side, a considerable part of total loss, is significantly reduced and higher efficiency can be achieved to obtain a compact and higher power density system. Steady-state operation, analysis, and design of the proposed topology have been presented. Simulation is conducted over software package PSIM 9.0.4 to verify the accuracy of the proposed analysis and design. A 500-W prototype has been built and tested in the laboratory to validate the converter performance.

High Voltage Input Zero Voltage Switch Multi-resonant Push-pull Topology with Minimized Conduction Loss for Primary Side

Research on High Efficiency DC/DC Converter in Grid-connected Fuel Cell Distributed Power System

Design and control of bi-directional DC/DC converter for 30kW fuel cell power system

A novel ZVS push-pull type LLC series resonant Dc-Dc converter for hybrid fuel cell power systems

A Novel Soft-Switching and Low-Conduction-loss Bidirectional DC-DC Converter

A New ZVCS Resonant Voltage-Fed Push-Pull Converter for Vehicle Inverter Application

Flying-Capacitor Based Hybrid LLC Converters with Input Voltage Auto-Balance Ability for High Voltage Applications

A High Step-Up DC to DC Converter under Alternating Phase Shift Control for Fuel Cell Power System

Three-phase interleaved high step-up boost converter with voltage multiplier for fuel cell power system

A Novel High-Gain DC-DC Converter Applied in Fuel Cell Vehicles

A Novel ZVS and ZCS Three-Port LLC Resonant Converter for Renewable Energy Systems

Bidirectional LLC resonant converter for energy storage applications

Active-Clamp ZVZCS Resonant Forward DC Transformer (DCX) with Load-Adaptive ON-Time Control

A ZVS Three-Port DC-DC Converter Based on Coupled Inductor for Fuel Cell Vehicle

Novel Interleaved Bidirectional Snubberless Soft-Switching Current-Fed Full-Bridge Voltage Doubler for Fuel-Cell Vehicles

A Novel Three Level Full Bridge Resonant DC/DC Converter Suitable for High Power Wide Range Input Applications

Single-Stage Single-Phase High-Step-Up ZVT Boost Converter for Fuel-Cell Microgrid System

Novel soft-switching push-pull type LLC resonant converter and its topology investigation

A High-Step-Up Low-Ripple and High-Efficiency DC-DC Converter for Fuel-Cell Vehicles

Switch Capacitor–Based High Step‐Up Three‐Port DC–DC Converter for Fuel Cell/Battery Integration

High efficiency soft-switched step-up DC-DC converter with hybrid mode LLC+C resonant tank