Abstract:This study focuses on how to verify the aerodynamic roughness parameters in an urban area by using Observational data collected in the roughness sub-layer. Anemometrical observations were made in the downtown area of Nanjing, China, in summer and winter. Data were collected using both slow and fast response anemometers Mounted on a 36 in tower. The friction velocity was observed just above the top of the urban canopy layer, which is at the height of 19.7 in, while the mean wind speed was observed at it relatively low level that is generally thought to be in the roughness sub-layer, of which the top usually ranges from 2 to 5 times the height of the urban canopy layer. The results of the measurements show that the dimensionless friction velocities (normalized by the mean wind speed at an upper level) maintain approximately a constant (0.20) and the fluctuations are small (+/- 0.02) in a period of 21 days. The results imply that the similarity relation for the mean wind profile is still valid and that the effect of stratification is negligibly small in the Lit-ban roughness sub-layer.Based on the measurement results, the logarithmic wind profile was applied to verify the aerodynamic roughness parameters empirically derived from four morphological models: the rule of thumb (Rt) method, the Bottema (Ba) method, the Macdonald (Ma) method and the Raupach (Ra) method. The results show that they are not very different from each other. The good performance of the Rt method may be due to the fact that the distribution of buildings in the study area is regular. The Ba and Ra methods are likely to be better since they can give reasonable estimates of roughness parameters. Evidence indicates that the Ma method underestimates the roughness length. Copyright (C) 2008 Royal Meteorological Society

Determination of Urban Surface Aerodynamic Characteristics Using Marquardt Method

Characteristics of the Drag Coefficient in the Roughness Sublayer over a Complex Urban Surface

Observational Verification of Urban Surface Roughness Parameters Derived from Morphological Models

Impact of Surface Variations on the Momentum Flux above the Urban Canopy

Exploring the Influence of Building Form Parameters on Three-Dimensional Ventilation Potential in Urban Centers: A Case Study of Nanjing, China

A Study on Determining Aerodynamic Parameters over Gobi Desert Surface

The Momentum Flux-Gradient Relations Derived from Field Measurements in the Urban Roughness Sublayer in Three Cities in China

Turbulence Characteristics in the Urban Surface Layer

A New Urban Canopy Parameterization Scheme for Wind Environment Simulations

Drag distributions of non-uniform buildings from surface pressure measurements in wind tunnel

A Refined Study of Atmospheric Wind Properties in the Beijing Urban Area Based on a 325 m Meteorological Tower

An Improved Method for Calculating Urban Ground Roughness Considering the Length and Angle of Upwind Sector

Assessment of Surface Drag Coefficient Parametrizations Based on Observations and Simulations Using the Weather Research and Forecasting Model

An Urban-Scale Method for Building Roofs Available Wind Resourceevaluation Based on Aerodynamic Parameters of Urban Sublayer Surfaces

Determination of Aerodynamical Parameter in Maqu Area in the Upper Reach of Yellow River and Its Application in Land Surface Process Model

Influence of Various Urban Morphological Parameters on Urban Canopy Ventilation: A Parametric Numerical Study

Turbulent transport mechanism in the roughness sublayers over idealized urban areas and its implication to street-level ventilation

Wind tunnel study on influences of morphological parameters on drag coefficient of horizontal non-uniform buildings

Surface Wind Pressure Tests on Buildings with Various Non-Uniformity Morphological Parameters

Analysis of turbulence intensity in the megacity of Beijing by High-frequency observations on a 325-m Tower

Parameterised Drag Model for the Underlying Surface Roughness of Buildings in Urban Wind Environment Simulation