Numerical Simulation for Air Distribution Optimization in a 750t/D Waste Incineration Furnace
Zhonglei Fan,Yi Lu,Yongzhen Meng,Qixuan Hu
DOI: https://doi.org/10.1080/00102202.2024.2435302
IF: 1.9
2024-12-15
Combustion Science and Technology
Abstract:Simulation research on the combustion process of municipal solid waste in a 750-ton/day incinerator was conducted by using the FLUENT software. The effects of excess air coefficient, the ratio of secondary air to burnout air, and the injection angle of secondary air SA1 or SA2 on the waste combustion process, flow field distribution, heat exchange efficiency of the incinerator, and the emission rules of flue gas NO x were studied. The results show that the optimal combustion conditions are 1.74 and 1.8 of the excess air coefficient, and 3 to 1 of the ratio of secondary air to burnout air. Moreover, the flow field inside the furnace was significantly affected by the injection angle of the secondary air. Under the given experimental conditions, there is a 5.2% enhancement in the heat exchange efficiency of the incinerator by adjusting the injection angle of SA1 to 45 degrees. Correspondingly, when the incinerator's efficiency is at 20%, it is equivalent to an overall efficiency increase of 1.4%. When the injection angle of SA2 is adjusted to 40 degrees, the heat exchange efficiency increases by 15.3% and the efficiency improvement is equivalent to 3.6%. In addition, compared to parallel injection of secondary air, this air distribution adjustment can maintain a higher flue gas velocity in the duct, reduce ash deposition on the boiler surface, and extend equipment life. These results provide the valuable insights for actual combustion scenarios.
energy & fuels,engineering, chemical,thermodynamics, multidisciplinary