Abstract:In order to simulate the flight state of the helicopter effectively, it is necessary to trim the helicopter during the forward flight in a wind tunnel test. Previously, due to the lack of an internal-control closed loop in the test rig, the helicopter-wind-tunnel-test trimming was carried out manually, with low test efficiency, unstable data quality, and high labor intensity. With the continuous development of computer technology and automatic control technology, the helicopter-wind-tunnel-test trimming technology has been developing in the direction of automation and intelligence. The helicopter wind tunnel test automatic trimming system is a typical multi-input–multi-output (MIMO), strongly coupled, and complex nonlinear system, involving data acquisition and a processing system, rotor control system, tail-supported mechanism control system, wind-tunnel-speed pressure control system, and other subsystems, which is difficult to describe with an accurate mathematical model. Therefore, in order to meet the needs of a 3 m diameter rotor model aerodynamic performance evaluation and noise characteristics research wind tunnel test, an error feedback variable step automatic trimming algorithm is proposed based on the fuzzy-control principle to realize automatic trimming of aerodynamic loads of rotor model in the forward flight state. To verify the effectiveness and reliability of the trimming strategy, a series of wind tunnel tests on a 3 m diameter scaled rotor model of a helicopter were conducted in the FL-17 aeroacoustics wind tunnel of China Aerodynamics Research and Development Center (CARDC) based on the Φ3m tail-supported helicopter rotor model wind tunnel test rig. The wind tunnel test's results show that the proposed automatic trimming algorithm has the characteristics of fast trimming speed and high efficiency, which can realize the automatic trimming of rotor model aerodynamic loads under different test states in the wind tunnel test effectively and reliably and greatly improve the intelligence level of helicopter wind tunnel test.

Trimming aircraft on the ground based on the hybrid genetic algorithm

A New Algorithm on Automatic Trimming for Helicopter Rotor Aerodynamic Loads

Some Improvements of Hybrid Trim Method for a Helicopter Rotor in Forward Flight

Optimal Performance Trim Procedure for Multirotor Vertical Takeoff and Landing Vehicles

Solving the Steady Flight State of Aircraft Based on Hybrid Genetic Algorithm

Trim State Discovery with Physical Constraints

Genetic Algorithm Based Constrained Control Allocation for Tailless Fighter

Intelligent optimization of landing gear retraction based on physical simulation

Overload Method for Low Penetration Aircraft and Digital Simulation

A feedback toolpath generation method for compound trimmed surface with machine’s dynamic characteristics confined

Study on the Test and Adjustment Method of Civil Aircraft Taxiing Deviation

A Method for Flight Test Subject Allocation on Multiple Test Aircrafts Based on Improved Genetic Algorithm

Modeling and simulation analysis of optimal layout scheme of aviation logistics park based on genetic algorithm

An Improved Genetic Algorithm Based on Reinforcement Learning for Aircraft Assembly Scheduling Problem

Control Parameter Optimization for a Longitudinal Automatic Landing System via a Multi-objective Genetic Algorithm

A hybrid trim strategy for coaxial compound helicopter

Airport take-off and landing optimization through genetic algorithms

Trim State Discovery for an Adaptive Flight Planner

Airport take‐off and landing optimization through genetic algorithms

Reachability analysis on optimal trim state for aerial docking

An integrated model for airport runway assignment and aircraft trajectory optimisation