Abstract:HCCI combustion was studied in a 4-stroke gasoline engine with a direct injection system. The electronically controlled two-stage gasoline injection and spark ignition system were adopted to control the mixture formation, ignition timing and combustion rate in HCCI engine. The engine could be operated in HCCI combustion mode in a range of load from 1 to 5 bar IMEP and operated in SI combustion mode up to load of 8 bar IMEP. The HCCI combustion characteristics were investigated under different A/F ratios, engine speeds, starts of injection, as well as spark ignition enabled or not. The test results reveal the HCCI combustion features as a high-pressure gradient after ignition and has advantages in high thermal efficiency and low NOx emissions over SI combustion. At the part load of 1400rpm and IMEP of 3.5bar, ISFC in HCCI mode is 25% lower and NOx emissions is 95% lower than that in SI mode. By introducing the second fuel injection in compression stroke, the stratified concentration is formed and the mixture is cooled, which means that HCCI ignition timing can be controlled and the load range can be extended by tuning mixture concentration and temperature. At critical ignition temperature, especially in SI/HCCI combustion mode transition, assisted spark ignition improves the stability of HCCI combustion. To better understand the physicochemical process within the cylinder, direct photographs on an optical engine using CCD camera had been used to analysis the intake, two-stage spray, compression and combustion process of the HCCI engine. The captured photographs show homogeneous lean charge could be realized by single fuel injection in intake stroke. Due to the intake swirl and squish flow during the compression stroke, the rich mixture formed by 2nd fuel spray are located near the spark. A great amount of spots are ignited simultaneously in fuel-rich zone, then it worked as an initiation to ignite the surrounding lean mixture zone. In this combustion system, a high intake swirl can be kept in the toroidal combustion chamber promoting fuel dispersion to reduce NOx emissions. Copyright © 2005 SAE International.

Effect of CO2 Intake and Cylinder Injection on Diesel Quasi-Homogeneous Charge Compression Ignition Combustion

Effects of CO2 In-Cylinder Injection on Diesel Homogeneous Charge Compression Ignition Combustion-Preliminary Study

Effect of Direct In-Cylinder CO2 Injection on HCCI Combustion and Emission Characteristics

Effects of Carbon Dioxide In-Cylinder Injection on Premixed Charge Compression Ignition Combustion

Effects of Compression Ratio and CO2 on the Process of HCCI Combustion Fueled with DME

Numerical Study on the Effects of CO2 and H2 on Combustion in a Dimethyl Ether HCCI Engine

Evaluation on the Effects of Compression Ratio, CO2 and LPG on HCCI Combustion Fueled with DME

Effect of CO2 dilution on combustion and emissions of a GDI engine under the peak NOX generation mixture

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Study of Diesel-Fuelled Homogeneous Charge Compression Ignition Combustion by In-Cylinder Early Fuel Injection and Negative Valve Overlap

Experimental Study on the Diesel Injection Pressure of Homogeneous Charge Induced Ignition for Multi-cylinder Operation

An Experimental Study of Hcci-Di Combustion and Emissions in A Diesel Engine with Dual Fuel

Exploring the Effects of the Key Multi-Injection Parameters on Combustion and Emissions in Intelligent Charge Compression Ignition (ICCI) Mode

Experiment on CCCI Combustion in a Engine Fueled with DME

Evaluation on Effects of Compression Ratio on DME HCCI Combustion Experiments

Effects of spark ignition and stratified charge on gasoline HCCI combustion with direct injection

Influence of Premixed Charge Compression Ignition and Direct Injection Combustion on Engine Performance

Effects of Pre-Injection Strategy on Combustion Characteristics of Ammonia/Diesel Dual-Fuel Compression Ignition Mode

Effects of engine load, inlet air temperature, valve overlap and EGR on diesel HCCI engine

HCCI combustion using DMM/diesel blend fuels by port-injection

Combustion and Emission Characteristics of Diesel Partial Homogeneous Charge Compression Ignition (P-Hcci) by Adding Fuel Injection in Negative Valve Overlap