Abstract:Abstract The direct-fired supercritical carbon dioxide cycles are one of the most promising power generation methods in terms of their efficiency and environmental friendliness. Two important challenges in implementing these cycles are the high pressure (300 bar) and high CO2 dilution (>80%) in the combustor. The design and development of supercritical oxy-combustors for natural gas require accurate reaction kinetic models to predict the combustion outcomes. The presence of a small amount of impurities in natural gas and other feed streams to oxy-combustors makes these predictions even more complex. During oxy-combustion, trace amounts of nitrogen present in the oxidizer is converted to NOx and gets into the combustion chamber along with the recirculated CO2. Similarly, natural gas can contain a trace amount of ammonia and sulfurous impurities that get converted to NOx and SOx and get back into the combustion chamber with recirculated CO2. In this work, a reaction model is developed for predicting the effect of impurities such as NOx and SOx on supercritical methane combustion. The base mechanism used in this work is GRI Mech 3.0. H2S combustion chemistry is obtained from Bongartz et al. while NOx chemistry is from Konnov. The reaction model is then optimized for a pressure range of 30–300 bar using high-pressure shock tube data from the literature. It is then validated with data obtained from the literature for methane combustion, H2S oxidation, and NOx effects on ignition delay. The effect of impurities on CH4 combustion up to 16 atm is validated using NOx-doped methane studies obtained from the literature. In order to validate the model for high-pressure conditions, experiments are conducted at the UCF shock tube facility using natural gas identical mixtures with N2O as an impurity at ∼100 bar. Current results show that there is a significant change in ignition delay with the presence of impurities. A comparison is made with experimental data using the developed model and predictions are found to be in good agreement. The model developed was used to study the effect of impurities on CO formation from sCO2 combustors. It was found that NOx helps in reducing CO formation while the presence of H2S results in the formation of more CO. The reaction mechanism developed herein can also be used as a base mechanism to develop reduced mechanisms for use in CFD simulations.

Kinetic Modeling On The Effect Of So2 Interactions On No Reduction During Methane Reburning

Kinetic Investigation of the So2 Influence on No Reduction Processes During Methane Reburning

Interactions of H2S and NO during the process of hydrocarbon reburning

Kinetic Modeling of Nitric Oxide Reduction by Natural Gas in Reburning Conditions

Numerical Simulation of Simultaneous NO and SO2 Reduction by Reburning

Kinetic analysis of nitric oxide reduction using biogas as reburning fuel

Experimental and Modeling Study of the Effect of CH(4) and Pulverized Coal on Selective Non-Catalytic Reduction Process.

Kinetic Study of Promoted SNCR Process by Different Gas Additives

Experimental and Kinetic Modeling Investigation of NOx Control in Coal Combustion by Ammonia Reburning

Kinetic Modeling Investigation on the NH3/C2H5OH/air Laminar Premixed Burning Characteristics at Different Equivalence Ratios

Characterizing Methane and Nitric Oxide Interaction in Oxygen-Free Outwardly Propagating Spherical Flame

Experimental Study on Coal Reburning Dynamic Process for NOx Reduction

Influence of Temperature and Oxygen Content on NO_x Reduction in Coal Gas Reburning Processes

Kinematic Similarity and Experimental Investigation for the Reduction of NOx by Natural Gas Recrudescence

Experimental Study on the Influences of the Water Vapor for the Methane Reburning Process

Experimental Study on the Time Evolutions of Methane Reburning and Combustion Process

Probing the Effects of NOx and SOx Impurities on Oxy-Fuel Combustion in Supercritical CO2: Shock Tube Experiments and Chemical Kinetic Modeling

Quantitative evaluation of NO formation and destruction routes during methane MILD combustion using an improved calculation method

Experimental and kinetic modeling investigation of NO x control in coal combustion by ammonia reburning

Characteristic Study on NOx Reduction with Coal-gas Reburning

Experimental Study on NOx Formation and Reduction by Shenhua Coal During Combustion and Reburning