Abstract:Electrolytic manganese residue (EMR) is a solid waste that contains a significant amount of soluble manganese and ammonia nitrogen, which can pose risks to human health if improperly disposed of. This study aimed to prepare cementitious materials containing abundant ettringite crystals by mixing EMR with various proportions of granulated blast furnace slag (GBFS) and alkaline activators (CaO, Ca(OH) 2 , clinker, NaOH). The resulting cementitious material not only utilized a substantial amount of EMR but also exhibited comparable strength to ordinary Portland cement. The optimal ratios were determined through mechanical testing. Additionally, the leaching toxicity of cementitious materials was assessed using ICP-MS (inductively coupled plasma mass spectrometer) tests. The microscopic properties, hydration, and mechanism of heavy metal solidification in the cementitious materials were evaluated using XRD (X-ray diffraction), SEM (scanning electron microscope), EDS (energy-dispersive spectrometer), FTIR (Fourier transform infrared spectroscopy), and TG (thermogravimetric) techniques. The results showed that the optimal ratio for the cementitious materials was 60% EMR, 36% GBFS, and 4% Ca(OH) 2 . The hardened mortar exhibited compressive strengths of 34.43 MPa, 41.3 MPa, and 50.89 MPa at 3 days, 7 days, and 28 days, respectively, with an EMR utilization rate of 60%. The hydration products of EMR-based cementitious materials were C-(A)-S-H, AFt, and ferromanganese compounds, which contribute to the mechanical strength. The Mn 2+ and NH 4 + -N contents of raw EMR were 1220 and 149 mg/L, respectively. Nonetheless, the leaching of Mn 2+ and NH 4 + -N in the alkali-EMR-GBFS system was significantly below the limits set by the Chinese emission standard GB8978-1996. Within this system, C-(A)-S-H and AFt could physically adsorb and displace heavy metals, Ca 6 Mn 2 (SO 4 ) 2 (SO 3 ) 2 (OH) 12 · 24H 2 O could replace Al ions with Mn ions, and ferromanganese compounds Fe 2 Mn(PO 4 ) 2 (OH) 2 · (H 2 O) 8 and MnFe 2 O 4 could chemically precipitate Mn 2+ .

[Dynamic Leaching Behavior of Heavy Metals in Eco-Cement Mortar Block].

Comparison of the Fixation of Heavy Metals in Raw Material, Clinker and Mortar Using a BCR Sequential Extraction Procedure and NEN7341 Test

Health Risk Assessment of Ecological Cement in Feed Water Systems

Factors affecting the leaching of heavy metals (Ni+2, Pb+2, Cr+3) contained in sludge waste stabilization/solidification by hydraulic benders, Part I: water/cement and waste/cement ratio in S/S mortars

Cement and zeolite stabilization/solidification of heavy metal-contaminated sediments: 841-Day leaching characteristics, mechanisms, and microstructure

Analysis of the Test Methods of Heavy Metal in Eco-Cement

Long-term Leaching Behaviours of Cement Composites Prepared by Hazardous Wastes

Field Test on Electro-Osmosis in a Heavy Metal Contaminated Soil: Electrokinetic Remediation and Reinforcement of the Soil

The Long-Term Leaching Behavior of Heavy Metals in Geopolymers and Portland Cement Bricks Containing Mswi Fly Ash: A Comparative Study

Assessment of the long-term leaching characteristics of cement-slag stabilized/solidified contaminated sediment

Strength and Leaching Characteristics of Magnesium Phosphate Cement-Solidified Zinc- Contaminated Soil under the Effect of Acid Rain

Study of microscopic properties and heavy metal solidification mechanism of electrolytic manganese residue-based cementitious materials

Experimental Study on Solidification and Stabilization of Heavy-Metal-Contaminated Soil Using Cementitious Materials

Green remediation of high-lead contaminated soil by stabilization/solidification with insoluble humin: Long-term leaching and mechanical characteristics

An evaluation of stabilised/solidified contaminated model soil using PC-based and MgO-based binders under semi-dynamic leaching conditions

Leaching Behavior of Heavy Metals from Cement Pastes Using a Modified Toxicity Characteristic Leaching Procedure (TCLP)

Comparison of the Fixation Effects of Heavy Metals by Cement Rotary Kiln Co-Processing and Cement Based Solidification/Stabilization

Study on heavy metal leaching behavior of waste concrete

Fly ash plastering mortar: heavy metal leaching rule, coupling mechanism and life cycle carbon reduction

Clarifying and quantifying the immobilization capacity of cement pastes on heavy metals

Potential Effect of Porosity Evolution of Cemented Paste Backfill on Selective Solidification of Heavy Metal Ions