Abstract:To avoid grain coarsening resulting from high-temperature carburizing, the effects of cyclic quenching and tempering on the microstructure and mechanical properties of 18CrNiMo7-6 gear steel were investigated. Three groups of samples were compared, which went through 0/1/3 times of quenching–tempering cycles after initial pseudo-carburizing. The variations in grain size, hardness, tensile strength, and toughness were systematically assessed using a series of experimental techniques. The experimental results indicate that the austenite grain size decreases from 14.8 μm to 5.0 μm as the number of cycles increases, accompanied by improved grain uniformity, which is beneficial to fine-grain strengthening mechanisms. During the phase transition, defects in the original martensite structure are transferred to the newly formed austenite, with the energy stored during the martensitic-to-austenitic transformation driving the grain refinement process. However, after several cycles of quenching and tempering, the release of some residual stresses and dislocations reduces the driving force for recrystallization, limiting further grain refinement. Although the strength decreased slightly after three cycles due to a reduction in dislocation density, toughness increased to a maximum of 172 J/cm2, primarily due to the enhancement of grain refinement and grain boundary density, which effectively hindered crack propagation. This study confirms the efficacy of cyclic heat treatment in refining grain structure and improving both strength and toughness, thereby contributing valuable insights to the research and development of high-performance gear steels.

Microstructure and Mechanical Properties of High Speed Steel after Cyclic Cryogenic Treatment

Effect of Deep Cryogenic Time on Martensite Multi-Level Microstructures and Mechanical Properties in AISI M35 High-Speed Steel

On the Use of Cyclic Cryogenic Treatment to Improve the Properties of High-Speed Steel

Microstructural variations and mechanical properties of deep cryogenic treated AISI M35 high-speed steel tempered at various temperatures

Effects of traditional heat treatment and a novel deep cryogenic treatment on microstructure and mechanical properties of low-carbon high-alloy martensitic bearing steel

Effect of tempering and deep cryogenic treatment on microstructure and mechanical properties of Cr–Mo–V–Ni steel

Effect of multiple deep cryo-treating and tempering on microstructure and property evolution of high carbon bearing steel

Effects of deep cryogenic treatment on the microstructure and friction performance of M35 high-speed steel

Effect of Deep Cryogenic Time on the Microstructure and Mechanical Property of Cr-Mn-Si High-Strength Alloy Steel

Effect of Deep Cryogenic Treatment on Microstructure and Properties of M35 High Speed Steel

Effect of Deep Cryogenic Treatment on Dilatometric Curve and Tribological Properties of High Speed Steel

Effect of Deep-Cryogenic Treatment on High Speed Steel Properties

Effects of deep cryogenic treatment on the microstructure evolution, mechanical and thermal fatigue properties of H13 hot work die steel

Microstructural Evolution and Mechanical Properties of 6cr13 Martensitic Stainless Steel Subjected to Cold Rolling and Heat Treatments

The Effect of Cyclic Heat Treatment on the Microstructure and Mechanical Properties of 18CrNiMo7-6 Gear Steel

Cryogenic Treatment of Ultrahigh Strength Steel TRm80

Microstructure and mechanical properties in core of a carburizing 20CrNi2MoV bearing steel subjected to cryogenic treatment

Effect of deep cryogenic treatment on carbon segregation in Cr8Mo2SiV tool steel during tempering

Enhancing Ductility of Martensitic Steels Through Cryogenic Treatment

The Effect of Cryogenic Treatment Temperature on the Mechanical Properties and Microstructure of 440C Martensitic Stainless Steel

Study on the Performance Improvement of Titanium Alloy through Deep Cryogenic and Thermal-cold Cycling Treatment