Correction of frequency spectrum for low frequency components

CHEN Kui-fu,WANG Jian-li,ZHANG Sen-wen

DOI: https://doi.org/10.3969/j.issn.1004-4523.2008.01.007

2008-01-01

Abstract:Several spectrum correction approaches have been developed, but their improvements deteriorate significantly when they are applied to the correction of the low frequency component (LFC). It is due to that the parameter model underlying the conventional approaches neglects the influence of the negative frequency in the real signal. A new approach is proposed to obtain the LFC parameters from fast Fourier transform (FFT) spectrum lines, which can take into account the contribution from the negative frequency. This explicit approach works only for the rectangular window, and makes use of three spectrum lines around the spectrum main lobe. The proposed approach has been validated by 351 × 180 simulation signal samples. The parameters in these simulated samples distribute widespread. The oscillating cycles covered in record (CiR) range from 1 to 8 by 0.02, and each CiR case included series samples with the initial phases increased from 0° to 179° by 1°. The maximum error by the proposed approach among 180 phase samples for each CiR is inspected. The simulation results show that so far as the aforementioned widespread parameters range is concerned, the frequency error of the proposed approach is no greater than 0.000 6Δω, where Δω is the FFT resolution. The errors of the amplitude and phase are not greater than 0.3% and 0.3°, respectively. The general trend of error decreases as the CiR increases, but fluctuation indeed exists with the local minimum error aligning with the coherent sampling where the CiR is an integer.