Abstract:Recycling methane from ventilation air is an effective means of reducing greenhouse gas emissions, improving gas utilization efficiency, and developing green mines. Regenerative oxidation properties of ventilation air methane (VAM) blending with dimethyl ether (DME) in a thermal reverse flow reactor were investigated. By analyzing the operating conditions, the influence of key process parameters on methane conversion was determined. The results showed that the addition of DME could greatly shorten the ignition delay time, lower the ignition temperature, and significantly enhance methane conversion. The initial temperature had the greatest influence on methane conversion, followed by methane concentration, whereas the effect of VAM flow on methane oxidation does not increase with an expanded flow rate, and there is an optimal flow rate range adapted to the reactor size. Additionally, methane conversion increases gradually as the equivalent ratio increases, but the temperature field does not change noticeably. Furthermore, understanding the reaction characteristics and mechanism of the CH4/DME mixture is critical for improving methane conversion and thermal utilization efficiency. Temperature sensitivity and rate of production during the oxidation process were analyzed, which revealed that R145 and R1 show positive effects, while R189 and R146 have an inhibitory effect at different DME mixing ratios and initial temperatures. For OH, the most significant promotional reaction was R1, while R27 had the reverse effect. In general, regenerative oxidation of the VAM/DME mixture contributes to an increase in methane conversion and stability of the self-sustaining operation of the system. Therefore, it is feasible to recover the thermal energy produced during the oxidation process for comprehensive utilization. This technology is of great practical importance for the improvement of methane utilization rates and the promotion of the objective of zero gas emissions in coal mines.

The Ventilation Air Methane Combustion System and Its Clean Development Mechanism Analysis

Capturing energy from ventilation air methane a preliminary design for a new approach

Thermodynamic, Economic and Environmental Evaluation of an Improved Ventilation Air Methane-Based Hot Air Power Cycle Integrated with a De-Carbonization Oxy-Coal Combustion Power Plant

A Comprehensive Heat-Equilibrium Analysis of Swiss-Roll Combustor and Its Thermal Energy Utilization System

Heat transfer analysis of Swiss-roll combustor for ventilation air methane

Utilization of ventilation air methane as a supplementary fuel at a circulating fluidized bed combustion boiler.

Analysis of the Effects of Structural Parameters on the Thermal Performance and System Stability of Ventilation Air Methane-Fueled Reverse-Flow Oxidation Reactors

Combustion Characteristics of Ventilation Air Methane Blending with Dimethyl Ether in a Thermal Reverse Flow Reactor

Study on characteristics of Ventilation Air Methane processing system

Numerical Simulation Study on Boiler Combustion Characteristics With Different Volume Fraction of Ventilation Air Methane

Experimental Study on Premixed CH4/air Mixture Combustion in Micro Swiss-roll Combustors

Experiment on Lean Fuel Combustion in Porous Media Combustor with External Swiss-roll

Clean Development Mechanism (CDM) project mitigation benefits of small and medium-sized biomass gasifiers

Experimental and Numerical Investigation of Ultra-Wet Methane Combustion Technique for Power Generation

Performance Evaluation of Low-Concentration Methane Combustion in a Four-Layer Gradually-Varied Porous Burner

Site Trials and Demonstration of a Novel Pilot Ventilation Air Methane Mitigator

Study on the Mechanism of Catalytic Oxidation of Ventilation Air Methane by Different Thermal Coals

Analysis on Combustion of Ultra-low Concentration Coal-bed Methane in Fluidized Bed System

Demonstration and its validation for ventilation air methane (VAM) thermal oxidation and energy recovery project