Abstract:Series active power filters (SAPF) can effectively suppress the line current harmonics generated by voltage-type harmonics sources. Yet the performance differs much in different control approaches. Generally there are two kinds of typical control strategies: voltage-source control and current-source control. The conventional control is voltage-source control in which the SAPF is controlled as a voltage source, and works just like frequency-selective impedance. It presents zero impedance for the fundamental frequency and acts as a resistor with high resistance of K [Omega] for harmonics frequencies. In late 1990s, some publications reported a new control strategy as current-source control in which the SAPF is controlled as a sinusoidal current source in phase with the utility voltage and with the amplitude as load needs. It is claimed that the current-source control has the priority of better performance, easy to implement, less time delay in digital control system, and most of all, with no stability problem. However, it is quite amazing that how current-source control can achieve all these better performances with just same power stage as voltage-source control and what is the nature between these two control strategies. This paper extensively compared these two control strategies in the view of the whole system, and found that the two control strategies, which seem entirely different in appearance, have identical control structure and operation principles. Simulation and experimental results are illustrated to verify the theoretical analysis. What's more, some previously confusing issues are discussed at the end to thoroughly express the author's view on the operation principle of SAPF.

An Advanced Dc Voltage Based Control for Series Active Power Filter

Dynamic DC-bus Voltage Control Strategies for a Three-Phase High Power Shunt Active Power Filter

A Novel Control Of Series Active Power Filter Without Harmonics Detection

A waveform control technique for high power Shunt Active Power Filter based on repetitive control algorithm

Design of DC-bus voltage controller for HAPF using low-pass filter

A Novel Control Approach for LCL-based Shunt Active Power Filter with High Dynamic and Steady-State Performance

A comparative study on voltage-source control and current-source control of series active power filter

High precision control strategy for three-phase four-wire Shunt Active Power Filter

A Series Active Power Filter Adopting Hybrid Control Approach

A Control Approach for Detecting Source Current and Series Active Power Filter

A Novel Fault-Tolerant Control Scheme for Shunt Active Power Filter with High Reliability

A novel fault-tolerant Shunt Active Power Filter and its control strategy

A Double-Loop Current Control Strategy for Shunt Active Power Filter with Lcl Filter

A simple method of realization of low power loss and high compensation-precision active power filter

Approaches to Shunt Active Power Filter for Application with Capacitive Nonlinear Load

On the control of active power filters

A New Control Strategy for Series Type Active Power Filter

DC Voltage Control Strategy Based on Active Disturbance Rejection Control for Active Power Filter

A Family of Voltage-Mode Control Methods for Active Power Filters and Comparative Analysis

Voltage type harmonic source and series active power filter adopting new control approach

A Novel Control of Parallel Active Power Filter for Fast-Changing Dynamic Load