Abstract:In this manuscript, a novel speed sensor‐less stator flux‐oriented vector control of DSIG machine has been proposed which has been incorporated in a grid‐tied, variable speed wind energy conversion system. This control scheme not only proves to be more efficient in terms of speed estimation but also increases robustness of the overall system. Moreover, omission of speed sensor not only increases the robustness of the system but also reduces the chance of error caused owing to mis‐measurement of speed by the speed encoder. The speed of the generator shaft is estimated from the motor terminal variables, that is, stator voltage and currents, so the system complexity gets increased to an acceptable extent. The overall control scheme is being simulated in MATLAB environment, and the results obtained in simulation are validated through appropriate experimental setup. Moreover, instead of using any DC motor as prime mover, an artificial wind generation unit is being constructed to form the experimental test bench. The paper proposes a novel speed sensor‐less stator flux‐oriented vector control of dual‐stator induction generator suitable for high‐power applications in grid‐tied wind energy conversion system. In this control strategy, the magnitude and angle of the flux are directly estimated by the measured stator voltages and currents. As the voltage and current sensors are placed on the stationery stator part, therefore, the proposed control strategy does not affect the robustness of the machine compared to the conventional rotor flux‐oriented vector control where the sensors need to be mounted on the rotating part of the machine. Moreover, the proposed speed encoder‐less stator flux‐oriented vector control eliminates the use of speed encoder, thereby reducing the cost and eliminating the error caused due to faulty speed measurement by the speed encoder of the overall system. The performance of the novel speed sensor‐less stator flux‐oriented vector control scheme has been verified by simulation and then experimentally on a 2 hp, 415 V, 50 Hz, three‐phase dual‐stator induction generator drive. The control strategy was implemented through dSPACE 1104 DAC card. From the simulated and the experimental results, it is evident that the proposed control strategy reflects improved performance w.r.t. conventional rotor flux‐oriented vector control.

A novel position sensor-less control scheme of doubly fed induction wind generator based on MRAS method

High-Frequency Signal Injection-Based Sensorless Control for Dual-Armature Flux-Switching Permanent Magnet Machine

Adaptive Sliding Mode Sensorless Vector Control of Induction Motor Using Sliding Mode MRAS Observer

Improved MRAS Observer and Sensorless Control of DFIG During Network Voltage Unbalance

Sensorless control of permanent magnet synchronous generator in direct-drive wind power system

Multiplane Rotor Resistance Online Estimation Strategy for Multiphase Induction Machine under Nonsinusoidal Power Supply

Sensorless DFIG System Control via an Electromagnetic Torque Based on MRAS Speed Estimator

Positioning Sensor-Less Control Method for Doubly Fed Induction Wind Power Generator

Improved Vector Control of Brushless Doubly Fed Induction Generator under Unbalanced Grid Conditions for Offshore Wind Power Generation

Improved MRAS Rotor Position Observer Based on Control Winding Power Factor for Stand-Alone Brushless Doubly-Fed Induction Generators

A Control Strategy for Doubly-fed Induction Generator Wind Turbines under Asymmetrical Grid Voltage Conditions Caused by Faults

Stator Voltage Oriented Variable-parameter Control Strategy for Wind Turbine Driven Doubly Fed Induction Generator

Sensorless Control of Ship Shaft Stand-Alone BDFIGs Based on Reactive-Power MRAS Observer

Speed-sensorless Control for Grid-Connected Doubly-Fed Induction Generators Based on Virtual Synchronous Generator

An SMC-MRAS Speed Estimator for Sensor-Less Control of DFIG Systems in Wind Turbine Applications

Harmonic and Fundamental Rotor Resistance Estimation Scheme for Multiphase Induction Motor Based on Nonsinusoidal Supply Control

A novel speed sensor‐less stator flux‐oriented vector control of dual‐stator induction generator for grid‐tied wind energy conversion system

Robust sensor-less sliding mode of second-order control of doubly fed induction generators in variable speed wind turbine systems based on a novel MRAS-ANFIS observer

Sensorless Voltage Control Schemes for Brushless Doubly-Fed Induction Generators in Stand-Alone and Grid-Connected Applications

A 2-D fuzzy logic based MRAS scheme for sensorless control of interior permanent magnet synchronous motor drives with cyclic fluctuating loads

Research of Speed Sensorless Vector Control of an Induction Motor Based on Model Reference Adaptive System