Abstract:In order to reduce operation and maintenance cost and improve fault diagnosis and detection accuracy for wind turbines, a study on advanced methods has been carried out. The purpose of this paper is to present a new method developed using radar chart and support vector machine (SVM) approach for fault diagnosis and prediction of wind turbine pitch system as it usually has a higher failure rate. In the study, the supervisory control and data acquisition (SCADA) system data are utilized as source data for SVM prediction. First of all, the characteristics of the indicator variable data collected by the SCADA system are analyzed, and the radar charts corresponding to the normal and faulty operation of the wind turbine pitch system are constructed using the indicator variable data. Secondly, the SVM method is used to extract the gray-level co-occurrence matrix (GLCM) features and histogram of oriented gradients (HOG) features of the radar charts, and the SVM classifier is trained. Then, the operational status is predicted, the classification effect is evaluated by the confusion matrix, and the prediction evaluation index is calculated. Thirdly, the support vector regression method is used to analyze the SCADA indicator variable data, the input and output of the regression model are determined, and the training prediction model is established, and the prediction accuracy of the test model is analyzed using the test sample data. Finally, the forecasting evaluation indexes obtained by the above two methods are compared. It proves that the proposed method using SVM to analyze the system radar charts has a higher prediction accuracy of 91.24% than the support vector regression method. The prediction accuracy is improved by 8.6%. Hence, it is verified that the new method using a radar chart and SVM approach has superiority over the support vector regression method.

Research on Sensors Fault Prognosis Learning Algorithm Based on Difference Evolution Cross Validation SVM in the Flight Control System

Support Vector Data Description with Model Selection for Condition Monitoring

Fault Detection and Isolation for Sensors on SUH Based on SVR and Wavelet Transform

Fault Detecting Using Support Vector Data Description With Genetic Algorithm

Research on Sensor Fault Detection and Signal Recovery Based on SVM

Fault diagnosis for sensors of aero-engine based on improved least squares support vector regression

Fault Diagnosis of an Autonomous Vehicle With an Improved SVM Algorithm Subject to Unbalanced Datasets

Fault Diagnosis For Esp Sensors Using Ls-Svm

A model to predict the residual life of aero-engine based upon Support Vector Machine

Application Research on Support Vector Machines in Mechanical Fault Diagnosis

Application of SVM Regression to Fault Diagnosis for Satellite

Prognostics of automotive sensors: Tools and case study

Research on Online Fault Prediction Model of Electronic Equipment Based on Online Sparse Least Square Support Vector Machine

A Support Vector Machine Based on Neural Dynamics Approach for Bearing Fault Classification

On Fault Prediction for Wind Turbine Pitch System Using Radar Chart and Support Vector Machine Approach

A novel compound fault-tolerant method based on online sequential extreme learning machine with cycle reservoir for turbofan engine direct thrust control

Research on Motor Fault Diagnosis in Support Vector Regression

A Novel Fault Detection, Identification and Prediction Approach for Autonomous Vehicle Controllers Using SVM

A Cuckoo Search-Support Vector Machine Model For Predicting Dynamic Measurement Errors Of Sensors

Application of Machine Learning to Engine Air System Failure Prediction

A Quantitative Intelligent Diagnosis Method for Early Weak Faults of Aviation High-speed Bearings