Abstract:There exist many approaches for gas turbine engine condition monitoring and fault diagnosis. Among them, gas path analysis depends on the relations between deviations of performance parameters and deviations of measurements, such as pressure, temperature, at some positions in the flow path. A dynamic tracking filter combined with a nonlinear gas turbine model can be used to implement a fault detection system. The dynamic tracking filter is composed with multiple feedback loops in which the residuals between model output and measurement are driven to zero by adjusting the performance parameters. In many cases, the number of measurement parameters is less than that of performance parameters, which impose a limit on the application of tracking filter in practical situations. In the present study, the tracking filter is retrofitted to be driven by the error between state of the model and the estimated state reconstructed from the engine measurement. For the time being, only linear time-invariant (LTI) state observer is considered. A nonlinear simulation model of the heavy-duty gas turbine under study is used to derive the linear system model needed for the design of LTI state observer. Input vector and output vector are chosen according to the practical situations. The linear system model obtained around the nominal operating point is observable, so a state observer can be designed. With 6 state variables observable from the engine, 6 performance parameters can be tracked with the proper design of tracking filter. The structure of the tracking filter consists of a static decoupling matrix DM and in series with 6 PI controllers.Deviations of performance parameters are implanted into the gas turbine model by scaling the performance maps used; and then simulation results are taken as measurements needed for the tracking filter to run. Tracking results of performance parameters in different case's are given to show the tracking capability for isolated performance deviations and concurrent performance deviations.

Dynamic Modelling And Robust Fault Detection Of A Gas Turbine Engine

Fault Detection Based on Operational State Recognition for Wind Turbine Gearbox

Algorithm and Experimental Validation for Condition Monitoring,fault Detection for Gas Turbine Engine

Research on Fault Detection Method Based on Adaptive Observer

Application of Fuzzy Inference System in Gas Turbine Engine Fault Diagnosis Against Measurement Uncertainties

Design Of Fault Detection System For A Heavy Duty Gas Turbine With State Observer And Tracking Filter

Actuator Fault Diagnosis and Severity Identification of Turbofan Engines for Steady-State and Dynamic Conditions

Fault Diagnosis of Aircraft Engines Based on Adaptive Sliding Mode Observers

Robust Adaptive Diagnosis for Multiple Faults of Aeroengine Actuator

Nonlinear Model Based Diagnostic Of Gas Turbine Faults: A Case Study

Fault Diagnosis for Actuator of Aero-Engine Based on Associated Observers

Robust Fault Detection Method of Aircraft Engine Sensors

Research on Model-Based Fault Diagnosis for a Gas Turbine Based on Transient Performance

Robust Diagnosis With High Protection To Gas Turbine Failures Identification Based On A Fuzzy Neuro Inference Monitoring Approach

Gas Path On-line Fault Diagnostics Using a Nonlinear Integrated Model for Gas Turbine Engines

A time-series turbofan engine successive fault diagnosis under both steady-state and dynamic conditions

A Hybrid Multi-Model-based Condition Monitoring and Sensor Fault Detection Method for Aero Gas Turbine

Physics-Based Modelling for On-Line Condition Monitoring of a Marine Engine System

Ensemble of DAEs for Fault Detection of Gas Turbine Engines

Actuator Fault Diagnosis of an Aero-Engine Based on Unknown Input Observers

Design Of Dynamic Tracking Filter For Model Based Diagnosis Of Gas Turbine Engine