Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Automatic suppression of white noise and repetitive pulses interference in on-site partial discharge monitoring

Analysis and Rejection of Noises from Partial Discharge (PD) On-Site Testing Environment

Discrimination of Three or More Partial Discharge Sources by Multi-Step Clustering of Cumulative Energy Features

An Automatic Tool for Partial Discharge De-Noising via Short-Time Fourier Transform and Matrix Factorization

On-line PD Data Analysis and Interference Suppression by Software

Analysis and Denoising of Electric Noise in Phased Array Ultrasonic Testing System

Detection and Identification Technologies of Wide Band Partial Discharge

Application and Improvement of Wavelet Packet De-Noising in Satellite Transponder

Application of Wavelet on Retaining the Shape of Partial Discharge Pulse of Power Cables

Noise suppressing techniques used for on-line monitoring of partial discharge in large generators

Enhanced Noise Suppression in Partial Discharge Signals via SVD and VMD with Wavelet Thresholding

A Novel Hybrid Approach for Partial Discharge Signal Detection Based on Complete Ensemble Empirical Mode Decomposition with Adaptive Noise and Approximate Entropy

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

Extraction of partial discharge pulse via wavelet shrinkage

Model of Integrative Denoise in On-Line PD Monitoring

A Pulse Interference Suppression Method Based on Double-Sensor Detection for PD Measurement in Frequency-Tuned Resonant Tests

Noise Rejection Techniques Used for On-Line Monitoring of Partial Discharges in Large Turbine Generators

Wavelet transform applying in partial discharge measurement

Partial discharge location of power cables based on an improved single-terminal method

Study of Noise-reject Technique for PD Online Monitoring on Cable Joint

Suppression of Pulse Interference in Partial Discharge Measurement Based on Phase Correlation and Waveform Characteristics