Abstract:In order to enhance the physical basis of the mass transfer model in numerical simulation of gas-liquid direct contact condensation and improve the fidelity, a set of methods and models are developed. Based on the concept of the piecewise-linear interface calculation (PLIC), an interface reconstruction algorithm is proposed to calculate the interfacial area concentration in three-dimensional non-orthogonal structured grids. The actual interface in the cell is replaced by a plane, whose position is determined iteratively to satisfy the local volume fraction and orientation of the actual interface. The area of the polygonal cut by the plane is taken as the interfacial area in the cell. The proposed algorithm is validated by calculating the surface area of a series of basic geometries. Obvious superiority of the proposed algorithm over the traditional models (gradient model and algebraic model) is seen. Then, the reconstructed area is used to determine the interfacial area concentration in the thermal phase change model. The process is implemented by ANSYS Fluent user-defined functions. The Stefan problem and steam bubble condensation experiment are used to test the performance of the developed methods and models. The simulation results agree well with the theoretical and experimental results with the quantitative relative errors no more than 4.3 % and 15 %, respectively. The oxygen jets condensation experiments are also used as test cases. The primary dominant frequencies predicted by the simulations are 163.01 Hz and 131.65 Hz, which agree well with the 139.72 Hz and 125.75 Hz in the experiments. The relative errors are only 17 % and 4.7 %. The unstable flow pattern of oxygen jet in liquid oxygen crossflow is explained based on the dynamic characteristics of turbulence, heat and mass transfer. The periodic variation of mass transfer rate is considered as the cause of condensation oscillation. The method for calculating the interfacial area proposed in this paper can serve as an optional and practical improvement to the numerical simulation of direct contact condensation.

A new model for distillation simulation

MODELING OF BATCH DISTILLATION STARTING FROM COLD STATE

A startup model for simulation of batch distillation starting from a cold state

Nonequilibrium model and parameter estimation on three-phase distillation in a packed column

Exploring the Essence of Three-Phase Packed Distillation: Substantial Mass Transfer Computation

Flow pattern identification for three-phase distillation with a nonequilibrium modeling

Study on the Numerical Model of Gas-Liquid Dispersion Driven by a Coaxial Mixer

Complex Hybrid Model for Startup of Batch Distillation

Modified Methodology For Distillation Modeling By Orthogonal Collocation

Aggregate Models Based On The Wave Propagation Theory For High-Purity Distillation Columns

Compartmental modeling and solving of large-scale distillation columns under variable operating conditions

A divergence-free mixture model for multiphase fluids

A Nonequilibrium Model for Distillation Processes

A Generalized Coupled Level Set/volume-of-fluid/ghost Fluid Method for Detailed Simulation of Gas-Liquid Flows.

CFD Simulation of Flow and Mass Transfer in Structured Packing Distillation Columns

Extending Mass Transfer Correlations For Packed Three-Phase Distillation Simulation: A Hierarchical Parameter Estimation Methodology

Research on Rigorous Mechanism Modeling for Distillation Column Series under Wide Variation of Feed Condition

Modeling and Control Design for Distillation Columns Based on the Equilibrium Theory

Development of a modified thermal phase change model based on the interfacial area concentration determined by an interface reconstruction algorithm

CFD Simulation of the Particle Dispersion Behavior and Mass Transfer–Reaction Kinetics in non-Newton Fluid with High Viscosity

Improvements in dynamic compartmental modelling of distillation columns