Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Two-layer zonal modeling of smoke movement in single fire room

Full-scale Experiments on Smoke Movement in a Two-Story Detached House with Two Horizontal Openings at the Lower-Floor Ceiling

EXPERIMENTAL STUDY ON AIR ENTRAINMENT COEFFICIENT DURING ONE-DIMENSIONAL HORIZONTAL MOVEMENT OF FIRE-INDUCED SMOKE IN LONG CHANNELS

Development of A Fire Zone Model Considering Mixing Behavior

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

Full-scale Experimental and Numerical Study of Smoke Spread and Temperature Distribution in a Room-Corridor Structure Building

Full-scale Experimental Study on the Smoke Descent and Stratification in a Two-Storey Building with Varying Ventilation Conditions

A multi-layer zone model for predicting fire behavior in a fire room

A Multi-Layer Zone Model for Predicting Temperature Distribution in a Fire Room*

Two Typical Phenomena from the Numerical Simulation of Fire and Smoke Transport in A Gymnasium Fire

Experimental and Numerical Study of Smoke Plumes in Stable Thermally Stratified Environments

Modelling the Maximum Ceiling Temperature with Bifurcated Plume in Tunnel Fires

Experimental Study on Fire Smoke Movement in a Multi-Floor and Multi-Room Building

Numerical Simulation of the Fire Smoke Flow in the Corridor of a Building

Smoke Spread Velocity along a Corridor Induced by an Adjacent Compartment Fire with Outdoor Wind

Full-scale experimental study on thermal smoke movement characteristics in an indoor pedestrian street

The Zone-Particle Model for Building Fire Simulation

Early fire smoke movements and detection in high large volume spaces

Numerical Simulation of Multistory Building Fire with Zone—modeling Method

Computational simulation of smoke temperature diffusing in high-rise building fire