Experimental Study on the Endwall Aerothermal Performance of Turbine Cascades in a Novel Transient Test Facility
Bo Bai,Mingyang Hao,Yuanyuan Li,Zhigang Li,Jun Li,Shuo Mao,Wing Ng
DOI: https://doi.org/10.1115/1.4066406
2024-01-01
Journal of Thermal Science and Engineering Applications
Abstract:Abstract A novel transient test facility was presented in this paper, including detailed design and structure, and various experimental measurements (aerodynamic and thermodynamic) were conducted to verify the transient test facility capability. This test facility mainly includes a main air supply line (bypass line and test line), a coolant supply line, a test section and a control system (heater and various valves). The linear cascade holds up 6 equally spaced cascade profiles, forming 5 completed cascade passages, and the center passage is used for aerodynamic and thermodynamic measurements. The aerodynamic loss and heat transfer performance were measured at various flow conditions (incidence angle, Ma and BR). The endwall heat transfer coefficient (HTC) and film cooling effectiveness (η) were estimated by adopting a dual linear regression technique (DLRT). Results indicate that the mianstream pressure and temperature present a desired step change, and remains relatively steady in the test window. The magnitudes of endwall heat transfer significantly increase as the exit Maex increases from 0.2 to 0.5, but the thermal load distributions remain the same. The blowing ratio (BR) is a key parameter for endwall film cooling performance, and the optimal film cooling coverage is acquired at the critical value of BR. Both insufficient and excessive coolant flowrate can result in undesirable endwall film cooling coverage, and may cause the unnecessary consumption of the coolant flow.