Abstract:The temporal Talbot effect supports the generation of RF signals with high purity in optical domain. This allows for example a remote RF generation without the need for costly high-end electronic circuits and resource sharing. However, one of the most interesting features of the approach is its inherent ability to suppress phase noise during the carrier generation process. Besides the comb laser source, the dispersive element is the key component in this upconversion scheme. Ideally, it provides the right amount of dispersion over the whole spectral range of the comb. Broader combs are expected to allow a higher degree of phase noise suppression. The simulation of phase noise of an RF tone generated by an optical scheme is challenging in terms of computational and memory effort. Therefore, a simulation tool taking advantage of the properties of the comb and the Talbot effect had to be developed. In this paper, the dependency of the phase noise suppression on the dispersion characteristic is investigated yielding an important input to the design of these elements. First, the implemented simulation tool and the simulation parameters ensuring a correct estimation of the phase noise before and after dispersion influence are introduced. Then, the effect of different dispersion characteristics on the phase noise behavior is analyzed. It could be shown and explained how the phase noise at different offset frequencies to the carrier is affected differently depending on the dispersion characteristic and also the comb width. Design rules for the required comb width as well as the acceptable variation of the produced dispersion from the ideal value depending on the demands for the phase noise improvements could be developed and will be presented.

Dispersion Induced RF Power Degradation in Optical True Time Delay Implemented by Broadband Light Source and a Dispersion Element

Mitigation of RF power degradation in dispersion-based photonic true time delay systems

Compensation of Dispersion-Induced Power Fading with Adjustment-Free Operation

The transmission performance degradation of the optical millimeter-wave signals by fiber chromatic dispersion

Noise Analysis in Photonic True Time Delay Systems Based on Broadband Optical Source and Dispersion Components.

Optical Controlled Microwave Time Delay Technology Based on Broad Band Optical Source

Impact of 3Rd-Order Dispersion on Photonic Time-Stretch System

Optical Dispersion Management for 10Gbps Upstream Directly-modulated Signals Covering Ranges from 0 to 100km with Maximal 51-dB Loss Budget

Optical true time delay method and system based on dispersion and frequency spectrum processing

Performance Evaluation For 160-Gb/S Optical Phase Conjugation Systems Considering Dispersion Mapping And Third-Order Dispersion

A Microwave Photonics Equalizer for Overcoming Dispersion-Induced Distortions on Wideband Signals in Radio-Over-Fiber Links

Compensation of dispersion-induced power fading for highly linear radio-over-fiber link using carrier phase-shifted double sideband modulation.

Compensation of Dispersion-Induced Power Fading in Radio-over-fiber System Based on Stimulated Brillouin Scattering

Influence of dispersive element on phase noise suppression in Talbot effect based optical upconversion scheme

Optical Amplification for BTDM-SFSW-Based Time Transfer

X-band Continuously Variable True-Time Delay Lines Using Air-Guiding Photonic Bandgap Fibers and a Broadband Light Source.

Novel Dispersion and Timing Estimation for Weakly-Coupled OAM Fiber Transmission Systems

Optical Single Sideband Modulation Based on Sagnac Interferometer Employing in True Time Delay

Delay Limit of Slow Light in an Optical Fiber

Simulation of Residual Dispersion on Stability of Optical Fiber Frequency Transfer System

Effects of Link Delay Fluctuations on Stability of Fiber-Optic Time Transfer