Abstract:Background: sEMG signal has been widely used in different applications in kinesiology and rehabilitation as well as in the control of human-machine interfaces. In general, the signals are recorded with bipolar electrodes located in different muscles. However, such configuration may disregard some aspects of the spatial distribution of the potentials like location of innervation zones and the manifestation of inhomogineties in the control of the muscular fibers. On the other hand, the spatial distribution of motor unit action potentials has recently been assessed with activation maps obtained from High Density EMG signals (HD-EMG), these lasts recorded with arrays of closely spaced electrodes. The main objective of this work is to analyze patterns in the activation maps, associating them with four movement directions at the elbow joint and with different strengths of those tasks. Although the activation pattern can be assessed with bipolar electrodes, HD-EMG maps could enable the extraction of features that depend on the spatial distribution of the potentials and on the load-sharing between muscles, in order to have a better differentiation between tasks and effort levels. Methods: An experimental protocol consisting of isometric contractions at three levels of effort during flexion, extension, supination and pronation at the elbow joint was designed and HD-EMG signals were recorded with 2D electrode arrays on different upper-limb muscles. Techniques for the identification and interpolation of artifacts are explained, as well as a method for the segmentation of the activation areas. In addition, variables related to the intensity and spatial distribution of the maps were obtained, as well as variables associated to signal power of traditional single bipolar recordings. Finally, statistical tests were applied in order to assess differences between information extracted from single bipolar signals or from HD-EMG maps and to analyze differences due to type of task and effort level. Results: Significant differences were observed between EMG signal power obtained from single bipolar configuration and HD-EMG and better results regarding the identification of tasks and effort levels were obtained with the latter. Additionally, average maps for a population of 12 subjects were obtained and differences in the co-activation pattern of muscles were found not only from variables related to the intensity of the maps but also to their spatial distribution. Conclusions: Intensity and spatial distribution of HD-EMG maps could be useful in applications where the identification of movement intention and its strength is needed, for example in robotic-aided therapies or for devices like powered- prostheses or orthoses. Finally, additional data transformations or other features are necessary in order to improve the performance of tasks identification.

Extraction of elbow joint intention from surface EMG signals in horizontal plane

Extraction of elbow joint intention from sEMG signals in horizontal plane using cosine tuning functions

THE INFLUENCE OF TORQUE AND ELBOW POSITION ON WRIST ROTATE ANGLE RECOGNITION BASED SURFACE ELECTROMYOGRAM

Estimation of Upper Limb Joint Angle Using Surface EMG Signal

Quantitative Relationship Modeling Between Surface Electromyography and Elbow Joint Angle

Mapping Method of Human Arm Motion Based on Surface Electromyography Signals

Simultaneous and Continuous Estimation of Shoulder and Elbow Kinematics from Surface EMG Signals

The Mapping Between Hand Motion States Induced By Arm Operation And Surface Electromyography

A Novel Exoskeleton Neuromuscular Interface Based on Motor Unit Action Potential Model Using High-Density Semg

EMG-Based 3D Hand Motor Intention Prediction for Information Transfer from Human to Robot

Motion estimation of elbow joint from sEMG using continuous wavelet transform and back propagation neural networks

Simultaneous and Continuous Estimation of Joint Angles Based on Surface Electromyography State-Space Model

Channel Synergy-based Human-Robot Interface for a Lower Limb Walking Assistance Exoskeleton

Real-time modeling and feature extraction method of surface electromyography signal for hand movement classification based on oscillatory theory

Human-robot Cooperative Control Based on Semg for the Upper Limb Exoskeleton Robot

Intelligent Human-Computer Interaction Based on Surface EMG Gesture Recognition

Human Motion Intention Recognition Method Based on Gasbag Human-Machine Interactive Force Detection and Multi-Source Information Fusion

HD-sEMG-based Research on Activation Heterogeneity of Skeletal Muscles and the Joint Force Estimation During Elbow Flexion

MCSNet: Channel Synergy-Based Human-Exoskeleton Interface With Surface Electromyogram

High-density surface EMG maps from upper-arm and forearm muscles

A Feasibility Study On An Intuitive Teleoperation System Combining Imu With Semg Sensors