Abstract:Propane dehydrogenation (PDH), an atom-economic reaction to produce high-value-added propylene and hydrogen with high efficiency, has recently attracted extensive attention. The severe deactivation of Pt-based catalysts through sintering and coking remains a major challenge in this high-temperature reaction. The introduction of Sn as a promoter has been widely applied to improve the stability and selectivity of the catalysts. However, the selectivity and stability of PtSn catalysts have been found to vary considerably with synthesis methods, and the role of Sn is still far from fully understanding. To gain in-depth insights into this issue, we synthesized a series of PtSn/SiO2 and SnPt/SiO2 catalysts by varying the deposition sequence and Pt:Sn ratios using atomic layer deposition with precise control. We found that PtSn/SiO2 catalysts fabricated by the deposition of SnOx first and then Pt, exhibited much better propylene selectivity and stability than the SnPt/SiO2 catalysts synthesized the other way around. We demonstrate that the presence of Sn species at the Pt-SiO2 interface is of essential importance for not only the stabilization of PtSn clusters against sintering under reaction conditions but also the promotion of charge transfers to Pt for high selectivity. Besides the above, the precise regulation of the Sn content is also pivotal for high performance, and the excess amount of Sn might generate additional acidic sites, which could decrease the propylene selectivity and lead to heavy coke formation. These findings provide deep insight into the design of highly selective and stable PDH catalysts.

Effect of Addition of Tin on the Catalytic Properties of Pt/ZSM-5 Catalyst in Propane Dehydrogenation

Effect of Sn Transformation on Catalytic Performance of Pt/Al2O3 Catalyst for Propane Dehydrogenation

Influence of the Severity of Reaction Conditions on the Promotional Effects of Tin in Pt–Sn/γ-Al2O3 Catalysts in Propane Dehydrogenation

Effect of Support Composition on Catalytic Performance of Ptsn/Zsm-5 Catalyst for Propane Dehydrogenation

Parametric Characterization and Influence of Tin on the Performance of Pt−Sn/SAPO-34 Catalyst for Selective Propane Dehydrogenation to Propylene

Modification of Zeolites with Tin to Synthesize Pt–Sn/MFI Catalysts for Propane Dehydrogenation

Effects of Synthesis Procedures on Pt–Sn Alloy Formation and Their Catalytic Activity for Propane Dehydrogenation

Propane Dehydrogenation over the PtSn Catalyst Supported on Alumina-Modified SBA-15

Strontium Promoted PtSn/Al2O3 Catalysts for Propane Dehydrogenation to Propylene

First-Principles Calculations of Propane Dehydrogenation over PtSn Catalysts

Effect of Ph on the Catalytic Performance of PtSn/B-ZrO2 in Propane Dehydrogenation

Catalytic Properties of Ptsn/Al2o3/Mcm-41 Catalysts for Propane Dehydrogenation

Effect of Ti-promoting on propane dehydrogenation over porous Zn-based catalysts: A strategy to enhance activity and selectivity

Co‐precipitation of Sn and Al Precursors to Create Additional Acid Sites of Pt/Sn‐Al2O3 catalysts for propane dehydrogenation

Influence of Operating Conditions, Si/Al Ratio and Doping of Zinc on Pt-Sn/ZSM-5 Catalyst for Propane Dehydrogenation to Propene

Propane Dehydrogenation over Supported Pt and Pt–Sn Catalysts: Catalyst Preparation, Characterization, and Activity Measurements

Atomically Precise Design of PtSn Catalyst for the Understanding of the Role of Sn in Propane Dehydrogenation

The Effect of Sn Content in a Pt/KIT-6 Catalyst Over its Performance in the Dehydrogenation of Propane

Preparation of Pt-Sn/Al2O3 Propane Dehydrogenation Catalysts by Sol-Gel Method and Their Properties

Optimizing propylene selectivity and stability over Pt–Sn/MgAl2O4 catalysts for propane dehydrogenation

Non-Oxidative Dehydrogenation of Propane to Propene Over Pt-Sn/Al2o3 Catalysts: Identification of the Nature of Active Site