Abstract:The electrochemical kinetic performance of the Ti0.8Zr0.2V2.7Mn0.5Cr0.8Ni1.75 hydrogen storage alloy electrode with particle size ranging from 100 mesh to below 500 mesh (∼139–27μm) has been systematically investigated during cycling. Results show that when the electrode discharges at the low current density as 100–200mA/g, the alloy electrode shows good high-rate dischargeability (HRD) even after 100 cycles, and the particle size only slightly affects the HRD value. While the discharge current density increases to 300–500mA/g, the HRD of the alloy electrode is obviously affected by the particle size. In other words, the effect of the particle size on the electrochemical performance becomes larger with increasing the discharge current density, especially for the post-cycled electrodes. For the post-5 and 15-times cycled electrode, the HRD of the alloy electrode increases first and then decreases with decreasing the particle size. On the contrary, the HRD of the post-110 times cycled alloy electrode first decreases when the particle size decreases from ∼139 to 59μm and then increases with further decreasing the particle size to ∼27μm. Further, EIS and micro-polarization investigations are in good agreement with the HRD behavior. Combined with SEM observations, it can be believed that it is the real size of the alloy particles, which was minimized by pulverization during cycling, rather than the original particle size, more effectively affects the electrochemical kinetics of the alloy electrode. In other words, not only the original particle size of the electrode alloy but also the pulverization and corrosion caused by the charge/discharge cycling affect the kinetic properties of the alloy electrode.

Intrinsic/Extrinsic Degradation of Ti−V-Based Hydrogen Storage Electrode Alloys Upon Cycling

Degradation Mechanisms of Ti–V-based Multiphase Hydrogen Storage Alloy Electrode

DEGRADATION BEHAVIORS OF NEW TYPE TiV-BASED HYDROGEN STORAGE ELECTRODE ALLOYS

A Study on the Cycling Stability of the Ti–V-based Hydrogen Storage Electrode Alloys

Electrochemical behaviors of a V3TiNi0.56Hf0.24 alloy electrode during charge–discharge cycling

Electrochemical Behaviors Of A V3tini0.5hf0.24 Alloy Electrode During Charge-Discharge Cycling

Effect of dehydrogenation depth on cyclic hydrogen desorption properties of V40Ti25.5Cr26.5Fe8 alloy

Pulverization Mechanism of the Multiphase Ti–V-based Hydrogen Storage Electrode Alloy During Charge/discharge Cycling

Corrosion Mechanism of Mechanically Alloyed Mg50ni50 and Mg45cu5ni50 Alloys

Structural and Electrochemical Characteristics of V2.1TiNi0.5Hf0.05M0.152 (M = Co, Cr) Hydrogen Storage Electrode Alloys

Microstructure and Electrochemical Properties of V2.1TiNi0.4Zr0.06Cux (X=0-0.12) Hydrogen Storage Alloys

Degradation Mechanism Of The La-Mg-Ni-Based Metal Hydride Electrode La0.7mg0.3ni3.4mn0.1

Cycling durability and degradation behavior of La–Mg–Ni–Co-type metal hydride electrodes

Degradation Mechanism of the La-Mg-Ni-Based Metal Hydride Electrode La[sub 0.7]Mg[sub 0.3]Ni[sub 3.4]Mn[sub 0.1]

Effects of Substitution of Co for Ni on Cycling Stability of Ti-V-Based Electrode Alloys

Influence of Cr or Co Doping on Electrode Properties of V 2.1 TiNi 0.5 Hf 0.05 Hydrogen Storage Alloy

The Effect of Particle Size on the Electrode Performance of Ti–V-based Hydrogen Storage Alloys

The effect of Hf content on the phase structures and electrochemical properties of V2.1TiNi0.5Hfx (x=0–0.25) hydrogen storage alloys

The Effects of Partial Substitution of Mn by Cr on the Phase Structure, Microstructure and Electrochemical Properties of Ti-Zr-V-Mn-Ni Hydrogen Storage Alloys

The Effects of Partial Substitution of Mn by Cr on the Electrochemical Cycle Life of Ti-Zr-V-Mn-Ni Alloy Electrodes of a Ni/MH Battery

Electrochemical kinetic performance of V–Ti-based hydrogen storage alloy electrode with different particle sizes