Abstract:Resonance acoustic mixing (RAM) technology is an attractive and safe mixing method for material mass and energy exchange. However, the mixing mechanism of this technology and the evolution law of the material in the container are complicated, and improper mixing conditions will make the material unable to reach uniformity quickly and efficiently. In this paper, a 90% solid polymer-bonded explosive (PBX) was prepared by RAM, and the evolution of materials in different mixing containers, mixing acceleration, and mixing time was studied. The binder system consisted of hydroxyl-terminated polybutadiene (HTPB)/dioctyl adipate (DOA) and was cured by isophorone diisocyanate (IPDI). Scanning electron microscopy (SEM) and Energy dispersive spectroscopy (EDS) were used to observe the microcosmic change of the sample during the mixing process, and a rheometer was used to measure the viscosity change of the slurry at different stages. The results showed that the hemispherical bottom vessel could achieve uniform mixing of materials within 45 minutes, and the mixing efficiency was highest when the acceleration was 40 g. According to the evolution state of typical materials, the mixing process was divided into 3 stages: rough cladding stage, the stage of converging into a smooth ball, and the flat fluidization stage. In the range of shear rates from 0.1 to 100s−1, the apparent viscosity of the material tended to be flat with the extension of mixing time, and the rheological behavior index of the material had little change after the material aggregates into a smooth ball. The density test of the cured sample further proved that the PBX was very uniform.

Application Study on a Polymer Bonded Plastic Explosive after Explosion Hardening

Study on Microstructures and Damage Evolution of a Substitute of Polymer Bonded Explosive

A new insight into the mechanical behavior of high-quality RDX in pressed polymer bonded explosives

Study on Dynamic Impact and Ignition Response Behavior of GAP/PET/RDX Based Propellant

Study on Mechanical Properties and Penetration Stability of DNAN Based Explosives Under Additive Effects

Study on energy release characteristics of reactive material casings under explosive loading

Experimental Investigation on the Enhancing Effect of Reactive Materials on Explosion Fireballs and Shock Waves of Composite Charges

Study on the Mechanical Behavior of New Type Explosion-proof and Impact-resistant Polyurea Elastomers

Experimental Investigation on the Performance of Polyurea-Coated Structure Under Blast Loads

Meso-Simulation and Experimental Research on the Mechanical Behavior of an Energetic Explosive

Research on Explosive Hardening of Titanium Grade 2

Visco-hyperelastic constitutive modeling of the dynamic mechanical behavior of HTPB casting explosive and its polymer binder

Ultrafine RDX / Al Preparation and Properties of Mixed Explosives

The Effect of Explosive Material on the Formation of Explosively Formed Penetrator

Mechanical Properties and Thermal Decomposition Mechanism of Glycidyl Azide Polyol Energetic Thermoplastic Elastomer Binder with RDX Composite

Preparation, High-Density Spherical, and Low Sensitivity of RDX/NC/PMMA Composite Particles

Evolution of HTPB/RDX/Al/DOA mixed explosives with 90% solid loading in resonance acoustic mixing process

Incidence of the explosive hardening in the performance of the Hadfield steel

Experimental analysis and multi-scale simulation of the fracture behavior of polymer-bonded explosives based on the dynamic notched semi-circular bend method

Design and characterization of high-performance energetic hydrogels with enhanced mechanical and explosive properties

The dynamic response of a high-density polyethylene slow-release structure under launching overload