Abstract:Direct evaporative cooling systems usually involve the process of spraying water, which may form the drift of water droplets. In addition, the use of circulating water can also lead to the growth of bacteria and molding on the surface of the packing material, affecting the indoor air quality. To address these issues, this paper intends to propose an evaporative cooling method incorporated with hollow fiber membranes. The selective permeation membrane technology allows the membrane module to isolate air from water, which selectively allows only water vapor to pass through, preventing the droplets from entraining bacteria into the air. A mathematical model has been developed to theoretically investigate the heat and moisture transfer between water and air in a hollow fiber membrane-based evaporative cooling module. The governing equations for the pre-cooling IEHX were established and then solved by employing the COMSOL Multiphysics platform. This study validated the model by comparing its outlet air dry bulb temperature and relative humidity against experimental data acquired from literature sources. The numerical model showed good agreement with the experimental findings with maximum discrepancy of 7.0%. The validated model was employed to investigate the influences of the inlet air velocity, inlet air dry-bulb temperature, inlet air relative humidity and geometric parameters on the cooling effect of the evaporative cooling module. Simulation results indicated that the outlet air temperature is greatly affected by the relative humidity of the inlet air under constant inlet air temperature conditions. A higher inlet air relative humidity will result in a higher outlet air dry bulb temperature. In addition, the cooling effectiveness was reduced for a higher inlet air velocity. The design of the hollow fiber membrane-based evaporative cooling module was optimized based on the simulation study.

Performance of Heat and Mass Transfer Based on Hydrophilic/hydrophobic Composite Membrane

Improvement of Thermal Performance of Novel Heat Exchanger with Latent Heat Storage

Parametric Studies On Membrane-Based Total Heat Exchanger Performance

Experimental and Theoretical Study on Heat and Mass Transfer of Hollow Fiber Membrane Heat Exchanger

Polyethylene/poly (N, N-dimethyl acrylamide) hybrid hydrogel membrane for total heat exchanger

Performance assessment of heat exchanger coated with encapsulated ultra-high salt content desiccant

Hydrophilic polymeric membrane condenser for heat and water recovery from flue gas: Performance analysis and feasibility evaluation

Performance Evaluation of a Direct Evaporative Cooling System with Hollow Fiber-Based Heat Exchanger

Mathematical Modeling of Gas-phase Mass Transfer in Hydrous Materials for a Total Heat Exchange Ventilator

Numerical Evaluation of the Effects of Asymmetric Membrane Heat Conductivity and Moisture Adsorption Hysteresis on the Performance of Air-to-air Membrane Enthalpy Exchanger

Study on the thermal performance of the cross-flow plate heat exchangers

Optimization of Membrane Condenser Process with PTFE Hollow Fiber Membrane

Performance Analysis of Membrane Separation Process for Water and Heat Recovery from Flue Gas

Simulation of Heat and Mass Transfer in Solution Heat Exchanger with Hollow Fiber Membrane

Heat and Mass Transfer Performance Study on Fuel Cell System Membrane Humidifier

Numerical Studies on Flow and Heat Transfer in Membrane Helical-Coil Heat Exchanger and Membrane Serpentine-Tube Heat Exchanger

Analysis of Thermal Performance and Energy Savings of Membrane Based Heat Recovery Ventilator

RESEARCHES OF MOISTURE TRANSFER PERFORMANCE IN THIN MEMBRANE

Airside characteristics of heat, mass transfer and pressure drop for heat exchangers of tube-in hydrophilic coating wavy fin under dehumidifying conditions

Analysis of DCMD-Based Hollow Fiber Membrane Heat Exchanger

Heat transfer performance of direct-contact flue-gas condensation heat exchanger