Abstract:Hydrodynamics in a 76mm i.d., 10.2m high circulating fluidized bed (CFB) riser and a 76mm i.d., 5.8m high CFB downer were studied for superficial gas velocities ranging from 2 to 5m/s and solid circulation rates up to 100kg/(m2s). Solid holdup, particle velocity and solid flux profiles in the radial and axial positions were presented. Under these operating conditions, axial solid holdup profiles in the riser and the downer could be approximated by an exponential decay function. The radial gradients of the solid holdup profiles in the riser were much higher than those in the downer, showing that the downer had much more uniform solid distribution. The average solid holdup for the entire riser was about 1.5 times higher than the predicted value from Gs/(ρpUg). However, for the downer reactor this ratio dropped to 0.45–0.98 which increased with increasing superficial gas velocity and decreasing solid circulation rate. Solid flow developed much slower in the riser than in the downer. Negative particle velocity was observed in the near-wall region for nearly the entire height of the riser. The average particle velocity for the entire riser was 0.8–0.96 times higher than the superficial gas velocity, and increased with increasing superficial gas velocity and decreasing solid circulation rate. However, in the downer the average particle velocity was 1.13–2.13 times higher than the superficial gas velocity, and increased with both superficial gas velocity and solid circulation rate. High local solid fluxes were observed in the near wall region of the CFB riser and downer reactor. Over-estimation of the calculated cross-sectional average solid flux over the solid circulation rate in the CFB riser was attributed to the fluctuations of the solid holdup and particle velocity.

Hydraulic characteristics of internal loop fluidized bed with baffle setting on bottom

Effect of Agitation on the Fluidization Behavior of a Gas–solid Fluidized Bed with a Frame Impeller

Gas Holdup and Liquid Velocity Distribution in a Jet Loop Reactor

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

Gas bubble behaviors in a gas–solid fluidized bed with an arch agitator

CFD Simulation and Hydrodynamics Characterization of Solids Oscillation Behavior in a Circulating Fluidized Bed with Sweeping Bend Return

Experimental Research on the Gas-Solid Flow Characteristics in Large-Scale Dual Fluidized Bed Reactor

Dynamic Characteristics of Solids Circulation Establishment in Laboratory and Industrial Circulating Fluidized Beds with Sweeping Bend Return

Hydrodynamics and Lateral Gas Dispersion in A High-Density Circulating Fluidized Bed Reactor with Bluff Internals

Structure optimization and flow field characteristics of baffle-type impinging stream reactor

Effect of Baffles on Solids Fraction in High Density Riser

CFD-DEM Study of the Effect of Ring Baffles on System Performance of a Full-Loop Circulating Fluidized Bed

Investigation on the Hydrodynamic Properties in the External Loop of Circulating Fluidized Bed with a Loop Seal

CFD method for the effect of baffle locations and baffle lengths on the hydraulic characteristics of a horizontal sedimentation tank

Investigation of hydrodynamics and mass transfer in an internal loop airlift slurry reactor integrating mixing and separation

Fundamental Studies on the Hydrodynamics and Mixing of Gas and Solid in A Downer Reactor

STUDY ON SOLIDS MIXING BEHAVIOR IN RISER-DOWNER-COUPLING CIRCULATING FLUIDIZED BED

Effects of internals on macroscopic fluid dynamics in a bubble column

A comparative study on hydrodynamics of circulating fluidized bed riser and downer

Discrete Element Study of Solid Circulating and Resident Behaviors in an Internally Circulating Fluidized Bed

Experimental Research on the Unstable Performances of Parallel External Loops in the Circulating Fluidized Bed