Abstract:This article presents a concise two-port asymmetric reciprocal filtering network, which mainly consists of short-and open-ended coupled lines for designing reflectionless bandpass filters (RBPFs). The network form is evolved from the lumped-element circuit to the distributed-element one. According to our theoretical analysis, it can be found that the network has the same transmission coefficients, i.e., $S_{\mathbf{12}}$ $=$ $S_{\mathbf{21}}$ . However, the reflection coefficients at the two ports are opposite. In other words, the magnitudes of $S_{\mathbf{11}}$ and $S_{\mathbf{22}}$ are the same ( $\vert S_{\mathbf{11}}$ $\vert$ $=$ $\vert S_{\mathbf{22}}\vert)$ while their phase difference is 180 $^{\circ}$ . Remarkably, this special 180 $^{\circ}$ relationship is frequency-independent. By resorting to this property, an asymmetric reciprocal filtering network can be developed by incorporating the filtering sections into the coupled lines. As a result, balanced-circuit-based RBPFs have been constructed without adding an extra phase shifter by arranging two filtering networks in a rotationally symmetrical manner. Benefiting from the frequency-independent antiphase reflection, the reflection signals of the two paths are canceled out in the stopband of the RBPF and absorbed by the isolation resistor of the employed power dividers (PDs). For demonstration, second-and fourth-order RBPFs using interdigital line resonators and split-ring resonators are, respectively, designed. Good agreements between the measured and simulated results can be observed.

Study on the choices of two-channel LPPRFB filters symmetry polarities and lengths

Study on Synthesis Filter Symmetry Polarities and Lengths of M-channel LPPRFB

Study on the filter's symmetry polarities and lengths of two-channel LPBFB

A Tri-Band Filter Using Tri-Mode Stub-Loaded Resonators (Slrs)

Low-Profile FSS-Based Polarization-Insensitive Rasorber with Switchable Transmission Band

Design of Circular/Dual-Frequency Linear Polarization Antennas Based on the Anisotropic Complementary Split Ring Resonator

Comparison of Fixed and Variable Sampling Frequency Digital PLL for Active Power Filters

The Rough Prototype and Fine Tuning (RP-FT) Method for Multiband Bandpass Filter Synthesis

Modeling and Analyzing High-Order Modes in Periodic-Stub-Loaded Stripline for Wideband Filter Design

High-Selective Bandpass Filters Based on New Dual-Mode Rectangular Strip Patch Resonators

Joint Design of Complementary Sequence and Receiving Filter with High Doppler Tolerance for Simultaneously Polarimetric Radar

Polar-Frame-Based Modeling and Small-Signal Stability Analysis of DDSRF-PLL: On the Different Implementation Structures Effect

Design of Polarization Band-Pass Filters Based on the Theory of Thin-Film Photonic Crystal Superlattice

A New Method of Realization of Adaptive Filtering in Polarization Domain

Design of Reflectionless Bandpass Filters Based on Asymmetric Reciprocal Filtering Network

Oversampled Linear-Phase Perfect Reconstruction Filterbanks: Theory, Lattice Structure and Parameterization

A Wideband Switchable L-Probe Patch Antenna with Reconfigurable Twelve Linear Polarizations and Dual Circular Polarizations

Research on Simultaneous Polarimetric Measurement Based on PN-NLFM Signals

Adaptive Filtering in Polarization Domain with the Criterion of LCMV

Balanced Wideband Bandpass Filter Design Based on Asymmetric Split Ring Resonators (asrrs) with Wide Stopband and Multi-Transmission Zeros

Synthesis Design of High Selectivity Wideband Balanced Bandpass Filter Based on Parallel Coupled Lines