Abstract:This paper studies a dual-wavelength single-frequency Er-doped fiber laser based on ring cavity, the output wavelengths are 1 570 nm and 1 548 nm. The laser combines Fabry-Perot (FP) filter and Fiber Bragg Grating (IFBG) to achieve wavelength selection and preliminary stabilization. And two unpumped Er-doped fibers act as saturable absorbers to realize linewidth narrowing effect. The Laser Diode (L.D) used has a maximum drive current of 700 mA, which corresponds to a maximum pumping power of 450 mW and 500 mW. When the pump power of LD1 is up to 58 mW and the diver current of LD2 is up to 138 mW, the fiber laser gets dual-wavelength output. The output power of the 1 570 nm and 1 548 nm laser generated at this time are 4.2 mW and 10.1 mW respectively. Then the pump power of LD1 and LD2 are adjusted to 104 mW and 83 mW respectively, and the output laser characteristics were studied under this condition. The output power in 1 570 nm is 10.3 mW, the Optical Signal to Noise Ratio (OSNR) is 58 dB. The output power in 1 548 nm is 4.7 mW, and the OSNR is 55 dB. It shows that the output laser has a relatively high-quality factor and high slope efficiency. Then the stability of the output laser is studied. In order to measure the stability of the output laser of the dual-wavelength single-frequency laser, data collection is started half an hour after the laser is turned on in the experiment. Every 10 min, the spectrum is collected and the output power is recorded. The power fluctuations of the laser output in 1 370 run and 1 548 nor are 0.01 dBm and 0.02 dBm, respectively, and the wavelength drifts of the output laser are both less than 0.01 nm. The result shows that the fiber laser can avoid the mutual interference between the two wavelengths. The output laser has good power stability and wavelength stability. The laser linewidth is the parameter of most concern fora single-frequency fiber laser. In this experiment, the linewidths of the output laser are measured by the delay non zero self heterodyne method based on the Mach-Zehnder interferometer and fitted with the Lorentz curve. And it can be calculated from the 20 dB bandwidth of the Lorentz curve. The linewidths of output laser in 1 570 urn and 1 548 urn measured are about 230.2 Hz and 223.6 Hz. The narrow linewidth indicates that the output laser has good single frequency performance, and it is also an important basis for the wide application of this laser. In this study, the idea of multiplexing Fiber Fabry-Perot (FFP) filter is proposed, and the two sub-cavities do not interfere with each other by introducing circulator at both ends of FFP. It also does riot introduce any expensive polarization devices, and does riot need to use a polarization controller to control the polarization state of the tight in the cavity. So it greatly reduces the difficulty of experimental operation and cost of the experiment. The fiber laser has a simple structure, good stability and the output laser has a narrow linewidth. It provides a technical method for realizing dual-wavelength single frequency laser output, and it can also be used as a seed tight source in high precision measurement field.

Single-frequency Bidirectional Cw Solid-State Ring Laser Pumped with a Fiber-Coupled Laser Diode

Experimental Research on the Diode-Pumped Solid-State Ring Laser

Fiber-solid, Hybrid, Single-Frequency Laser (100 W) with a 100 MHz Repetition Rate and 1 Ns Pulse Width from a Spherical Aberration Compensated Four-Stage Nd:YVO4 Amplifier

Experimental Research on the Stability and the Multi-Longitudinal Mode Interference of Bidirectional Outputs of Ld-Pumped Solid-State Ring Laser

Longitudinal-Mode Analysis and Selection of the Bi-Directional Ld-Pumped Solid Ring Laser

Novel Single-Frequency Diode Pumped Solid-State Lasers and Their Applications in Laser Ranging and Velocimetry

Study of the Characteristics of Laser Diode with Fiber Bragg Grating External Cavity

Narrow Line-Width Ytterbium-Doped Fiber Ring Laser Based on Saturated Absorber

Single-frequency pulsed fiber laser based on an electro-optic modulator with injection seeding technique

Cr:Yag Passively Q-Switched Single-Frequency Nd:Yvo4 Ring Cavity Laser

Single-frequency linear cavity erbium-doped fiber laser for fiber-optic sensing applications

23 KHz linewidth 1064 nm SOA based fiber laser by using parallel type subring cavities

Sesam Mode-Locked Yag Laser With Ld Side Pumping Module

A 1-μm-Band Injection-Locked Semiconductor Laser with a High Side-Mode Suppression Ratio and Narrow Linewidth

On The Characterization Of A Green-Light Directly-Modulated Diode-Pumped Solid-State Laser

Experimental study on LD pumped solid state laser gyro

High-power narrow-linewidth diode laser based on external cavity feedback technology for Yb: YAG pumping

LD-Pumped 228 nm Nd:GdVO4/Cr4+:YAG Passively Q-Switched Solid-State Laser

Investigations of the High-Power, Single-Frequency, Sub-Microseconds, 1548-nm Fiber Laser Based on the Optical Pulse Modulation

Laser diodes semicircular side-pumped laser rod with a round-sharped output

1 570 nm and 1 548 nm Dual-wavelength Single-frequency Er-doped Fiber Laser