Abstract:Metal-free polymer graphite carbon nitride (CN) is a promising photocatalyst that has garnered significant research attention. However, unmodified CN possesses several shortcomings such as low specific surface area, poor dispersibility in water, and rapid photogenerated electron-hole recombination, which have severely impacted its mass adoption. Here, this study proposed a two-step heat treatment method to incorporate P dopant and the containing-oxygen groups successively into CN. The final product, denoted as PO-CN, possessed a porous ultrathin nanosheet-like morphology. The introduction of P dopant altered the intrinsic electronic structure of CN. Meanwhile, the presence of oxygen-containing groups improved the dispersibility of PO-CN in water. Also, it led to the formation of a porous ultrathin structure that could provide more active sites. Through the synergistic effects of these two methods, PO-CN demonstrated superior photocatalytic performance compared to the unmodified counterpart. Based on the collective results obtained experimentally and theoretically, PO-CN possessed a porous ultrathin structure, low resistance, and low carrier recombination. The results show an optimal hydrogen evolution rate of PO-CN (997.7 mol h(-1) g(-1)), which was 11.2 times and 3.22 times that of the CN (88.89 mol h(-1) g(-1)) and PCN (310.3 mol h(-1) g(-1)). Moreover, PO-CN was then used in the degradation of Rhodamine B, and a degradation kinetic constant (k) of 0.15009 was calculated, which was 18.42 times and 8.22 times higher as compared to those of CN (0.00815) and PCN (0.01826). Hence, this work provides a new strategy for the alteration of the morphology and electronic structure of CN.

Effect of Concentration of Nitrogen Oxidizes on Photocatalytic Oxidation Efficiency of Nano TiO2 Photocatalyst Immobilized on Cement-Based Material

Study on the Photo-Catalytic Properties of Nano-TiO<sub>2</sub> Cementitious Materials

Application Research on Polymer Cement Mortar Incorporated with Nitrogen Modified Nano-Tio_2 Photocatalysis Material

Photocatalytic Degradation of Vehicle Exhaust by Nano-TiO2 Cement Slurry: Experimental Factors and Field Application

Study on Photo-Catalytic Efficiency of Nitrogen-Doped Nano-TiO2

NO x degradation by cement mortar containing B-TiO 2 /MgAl-CLDH under visible light: Experimental and modeling

Ti3C2 MXene modified g-C3N4 with enhanced visible-light photocatalytic performance for NO purification

Study on Photo-catalytic Efficiency and Durability of Nano-TiO2 in Permeable Concrete Pavement Structure

Evaluation of Nitrogen Oxide Reduction Performance in Permeable Concrete Surfaces Treated with a TiO2 Photocatalyst

Oxygen-containing Groups and P Doped Porous Carbon Nitride Nanosheets Towards Enhanced Photocatalytic Activity.

Fluoride-Etched TiO2 Microspheres Modified with Al2O3 for Enhanced Photocatalytic Conversion of NOx into Nitrate ions

Bed Flow Photoreactor Experiments to Assess the Photocatalytic Nitrogen Oxides Abatement under Simulated Atmospheric Conditions

Development of TiO2–CaCO3 Based Composites as an Affordable Building Material for the Photocatalytic Abatement of Hazardous NOx from the Environment

Photocatalytic oxidation of nitrogen oxides using TiO2 loading on woven glass fabric

Composite nanoarchitectonics with TiO2 nanocrystals and superior thin Ti3C2Tx nanosheets towards efficient NO removal

Photocatalytic concrete paving block reinforced by TiO2 nanotubes for NO removal

Preparation and Photocatalytic Hydrogen Evolution Performance of C-N Co-doped Nano TiO_2 Photocatalysts

Characterization of Metal Doped-Titanium Dioxide and Behaviors on Photocatalytic Oxidation of Nitrogen Oxides

Photocatalytic Oxidation of Nitric Oxide with Immobilized Titanium Dioxide Films Synthesized by Hydrothermal Method

Characterization and activity of Pd-modified TiO2 catalysts for photocatalytic oxidation of NO in gas phase.

Field Evaluation of Ability of Photocatalytic Concrete Pavements to Remove Nitrogen Oxides