Abstract:Eddy current damping has been widely applied in mechanical engineering; however, its adaptation for civil engineering applications remains rather limited due to its low density of energy dissipation. This study presents the development of a new type of eddy current damper and theoretical and experimental characterization of its damping properties. In addition to rectangular permanent magnets and conductive plate, both primary back iron and secondary back iron are considered in the proposed eddy current damper, which represents an improved design over previous configurations. The analytical method based on the charge model of permanent magnets is extended to simulate the extra damping effect of the primary back iron and secondary back iron, and the magnet field and damping properties of the dampers are evaluated analytically. The use of a back iron in the proposed damper is shown to increase the damping coefficients by a factor of up to 5. The analytical results are compared with those obtained with the finite-element analysis in terms of accuracy in magnetic field distributions, eddy current distributions, and damping coefficients. The linear assumption, which implies the damping force is linearly proportional to velocity in the analytical model, is also examined for different motional velocities and relative permeability of the permanent magnet. It is shown that the linear damping assumption in the analytical model is only valid for a limited range of low velocity, and this velocity range can be increased by reducing the thickness or conductivity of the conductive plate. In addition, a modification is needed for the analytical model if the relative permeability of the permanent magnet significantly deviates from the assumed value of 1.0. Finally, the accuracy of the analytical model and the finite-element model is verified by experiment of a prototype damper mounted in a laboratory steel frame.

Closed-loop Control Strategies and Dynamical Tests of the Electromagnetic Mass Damper Control System

Dynamic Models for Magnetorheological Dampers and Its Feedback Linearization

Experimental Investigations on the Nonlinear Dynamics of Magnetorheological Dampers

Dynamic Characteristics and Modeling of A New Magnetorheological Damper for Broadband Vibration Control

Research On Dynamic Characteristics Of A Magnetorheological Damper With Decoupling Mechanism

Studies on a Passive Electromagnetic Damper

A STOCHASTIC OPTIMAL SEMI-ACTIVE CONTROL STRATEGY FOR ER/MR DAMPERS

A Bounded Stochastic Optimal Semi-Active Control

Study and Experimental Verification on Anti-Disturbance Control Strategy for Electro-Mechanical Servo Systems

Stochastic Optimal Semi-Active Control of Hysteretic Systems by Using A Magneto-Rheological Damper

Vibration Control of a Radial Journal Eddy Current Damper on Flexible Rotor Systems

Modeling, Testing, and Validation of an Eddy Current Damper for Structural Vibration Control

A Semi-Active Stochastic Optimal Control Strategy for Nonlinear Structural Systems with Mr Dampers

Experimental Study on the Semi-Active Control Strategies of Magnetorheological Damper

Self-Sensing Approach for Semi-Active Control of Variable Damping Electromagnetic Suspension System

Research on Control Strategy for Simulation Working Condition Test-Bed of Magneto-Rheological Fluid Damper

Research on the Sensing Properties and Vibration Reduction Performance of Self-Sensing Self-Tuning Magnetic Fluid Damper

A Current-Differential-based Method for Improving Dynamic Characteristics of Electromagnetic Actuators

Optimal Design of Tuned Mass Dampers With Variable Inerter and Damping

Disturbance Observer Based Controller Design for Electric Dynamic Load Simulator

Vibration Attenuation System Featuring Electro-Rheological Damper with Semi-active Static Output Feedback Fuzzy Sliding Mode Control