Abstract:This paper describes the process of conceptualization, design, and testing of the Onboard Computer (OBC) Software for a 3U nanosatellite. The on-board computer of the satellite is responsible for initiating dataflow between onboard hardware, performing image compression, and run control algorithms like fine pointing, sun pointing, ground pointing for payload operation and idle state detumbling. The actuation is carried out by interfacing magnetorquers and reaction wheels with the OBC. The software of the onboard computer is implemented on a Linux based operating system run on the ARM Cortex A9 processor which is part of the Zynq-7000 SoC. A Field Programmable Gate Array (FPGA) is used specifically for image compression. The compressed image is stored in a serial flash memory shared between the camera and the FPGA. The architecture comprises of a system-wide I2C bus to which the sensors interfaced. The collected data is used for logging followed by downlink and as input to algorithms used for pointing and detumbling. An SPI interface is used between the Power Subsystem microcontroller and the On-Board Computer since a large amount of housekeeping data will have to be exchanged at high rates. Reaction wheels and magnetorquers are actuated by current driver circuits which get the control signals from the OBC. The satellite is modelled as a Finite State Machine for software development. The states broadly fall under two categories, Normal and Emergency. Each state has a predetermined set of logical tasks to be run, which are abstracted as separate processes in the memory. State transitions take place by polling the health metrics of the satellite. However, hardware interrupts are implemented on selected peripherals which ensure an asynchronous switching to the Emergency States for safety. A review of some common fault detection, isolation and removal methods used shall conclude the paper.

Design of on-board parallel computer on nano-satellite

Research on Reliability and Real-Time of On-Board Computer Based on RT-Linux

Logical Architecture Design of Integrated Electronic System with High Real-Time and Reliability in ZDPS-2 Pico-Satellite

UML Based Design Approach for Storage System of Nano-Satellite

Design and implementation of interconnection of on-board parallel computer

On Board Computer Subsystem Design for the Tsinghua Nanosatellite

Development of On Board Computer for a Nanosatellite

Design and Implementation of Fault-tolerant Parallel Algorithm Towards On-board Computer

The design of an adaptive on-board computer for small satellites

Reconfigurable Multi-processor On-board Computer for Small Satellites and Small Launch Vehicles

Design and in-orbit verification of data storage system for nano-pico satellites

On-board computer system design for satellites based on system C

Integrated Platform of On-Board Computer and Star Sensor Electronics System Based on COTS

Design and Implementation of a Low-Cost Fault-Tolerant On-Board Computer for Micro-Satellite

Research of the small satellite data management system

Application-Oriented On-Board Software Management System for Micro-Nano Satellite

The New Fault Tolerant Onboard Computer for Microsatellite Missions

Design of Onboard Avionics Based on Commercial Off-the-Shelf Parts for TianQi-2 Nanosatellite

DEVELOPMENT OF ONBOARD CONTROL SYSTEM ARCHITECTURE FOR NANOSATELLITES

Design of Computer System for Pico-satellite Based on TOPSIS Method

Advances in the design and application of a high performance micro-nano remote sensing satellite