Abstract:Large-mode-area photonic crystal fiber is used to generate high power, high beam quality supercontinuum. Propagation and supercontinuum generation process of laser pulse in large-mode-area (LMA) photonic crystal fiber (PCF) is simulated by solving the general nonlinear Schrödinger equation (GNLSE) using the split-step Fourier method. Effects of the pump pulse parameters (peak power and chirp) and the length of photonic crystal fiber used on supercontinuum generation are particularly estimated. Nonlinear spectral broadening mechanism of laser pulse in large-mode-area photonic crystal fiber is discussed. The results show that the process of supercontinuum generation can be divided into three stages: initial broadening, dramatic broadening and saturation broadening. The spectrum width and efficiency can be achieved by the optimized length of LMA PCF to insure output of the generated supercontinuum at the dramatic broadening stage. The pump peak power and chirp have important impact on supercontinuum generation. When a small peak power pump is input, the spectrum broadens symmetrically. When the pump peak power increases, it brings little changes with the shorter wavelength component but broader of the longer wavelength component. The time-domain shape of the pulse exhibits concussion modulation as the effect of pulse breakup. When the pump chirp is positive, little influence is shown, except a shift of longer wavelength power by increasing the chirp. But the full width of the supercontinuum has little changes. While the pump chirp is negative and satisfy certain condition, the nonlinear is enhanced to facilitate the supercontinuum generation.

Effect of Initial Chirp on Supercontinuum Spectrum in the Dispersion-flatted Fiber with Convex Dispersion Profile

Chirped fiber grating with the apodization of parabola squared function for dispersion compensation of chirped Gaussian pulses

Effects of Pulse Chirp on Supercontinuum Produced in Dispersion Decreasing Fibre

Supercontinuum generation based on nanofiber

Effects Of Pulse Chirp To Supercontinuum Producing

Experimental and Numerical Study of Supercontinuum Generation in Photonic Crystal Fiber

Dispersion Broadening and Compensation of Non-Chirp Original Gaussian Optical Pulse

Theoretical and Experimental Study of Supercontinuum Generation in the Dispersion-Shifted Fiber

Effect of chromatic dispersion induced chirp on the temporal coherence property of individual beam from spontaneous four wave mixing

Experimental Analysis of the Dependence Factor During Supercontinuum Generation in Photonic Crystal Fiber

Broadband flat supercontinuum generated by chalcogenide double-clad step-index fiber with special dispersion

Theoretical and Experimental Study of Supercontinuum Generation in Optical Fibers

19-Fs Pulse Generated by Supercontinuum Compression

Suppression of Residual Pump Component for Flat Supercontinuum Generation in Dispersion-Flattened Dispersion-Decreasing Fibers

[Study on the Supercontinuum Generation with Femtosecond Pulse in Photonic Crystal Fiber].

Supercontinuum generation and control from large-mode-area photonic crystal fiber

An Efficient Method for Supercontinuum Generation in Dispersion-Tailored Lead-Silicate Fiber Taper

Relaxed Dispersion Requirement in the Generation of Chirped RF Signals Based on Frequency-to-time Mapping

Supercontinuum Generation in Photonic Crystal Fiber and Tapered Single-Mode Fiber

Low-noise supercontinuum generation in chiral all-normal dispersion photonic crystal fibers

Circular lattice benzene-core PCFs with flat near-zero dispersion for low-power broad-spectrum supercontinuum generation