Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Residual Vibration Suppression of Flexible Arms Using Er Adaptive Structures

Active Vibration Control of Flexible Structures with Super-Coiled Actuators

Random Vibration Control for Multi-Degree-of-freedom Mechanical Systems with Soft Actuators

Distributed Structural Dynamics Control of Flexible Manipulators—ii. Distributed Sensor and Active Electromechanical Actuator

Vibration Characteristics of Electrorheological Elastomer Sandwich Beams

VIBRATION SUPPRESSION OF ROTATING FLEXIBLE BEAMS USING ER FLUIDS: EXPERIMENTAL WORK

Active vibration control of smart composite structures

Vibration Control of Variable Speed/Acceleration Rotating Beams Using Smart Materials

Application of Electrorheological Fluid to Vibration Control of Structures

Application of ER fluid in structural vibration control

MICRO-VIBRATION SUPPRESSION OF EQUIPMENT SUPPORTED ON A SANDWICH BEAM INCORPORATING MAGNETO-RHEOLOGICAL ELASTOMER (MRE) CORE

Dynamics and Distributed Vibration Controls of Flexible Manipulators; Integrated Distributed Sensing and Active Piezoelectric Actuator

Study on Vibration Attenuation Performance of A New Structural Electrorheological Fluid Damper

Active vibration control system of smart structures based on FOS and ER actuator

Dynamic Modeling and Vibration Suppression of Double Flexible Mechanical Arm System

Vibration Characteristics of Rotating Sandwich Beams Filled with Electrorheological Fluids

Micro-vibration suppression of equipment supported on a floor incorporating magneto-rheological elastomer core

Multiflexoelectric Actuation and Control of Beams

Dynamic performance of cantilever mortar beams with embedded electro-rheological fluids

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Structural vibration control using spatially configured opto-electromechanical actuators