Abstract:This paper presents a 0.2 similar to 3.8-GHz in-band (IB) full-duplex (FD) mixer-first receiver based on a vector self-interference (SI) canceller. To ensure the wideband orthogonality of the reconstructed SI signal while minimizing the noise figure (NF) degradation in FD mode, a low insertion loss two-stage polyphase filter (PPF) with a lacking resistance and capacitance (LRC) structure is used in the SI canceller. A 6-bits passive capacitor digital to analog converter (C-DAC) attenuator not only realizes the high-precision amplitude adjustment of the reconstructed SI signal but also avoids the linearity limitation of the back-end modules of the canceller and reduces the noise contribution of the front-end modules at the canceller output. A four-phase mixer-first receiver with enhanced out-of-band (OOB) interference suppression is designed to provide sufficient linearity to reduce the SI-induced nonlinear distortion. As a proof of concept, a prototype FD receiver is fabricated in CMOS 65 nm technology and measured in chip-on-board (COB) package. Measurement results show that it can operate in the frequency range of 0.2 similar to 3.8-GHz with more than 25 dB SIC amount for 10 MHz bandwidth (BW) 64-QAM modulated signals in fixed (30 dB) channel attenuation test setup. The receiver achieves OOB input-referred third-order intercept point (OOB-IIP3) of +24 dBm and OOB input-referred second-order intercept point (OOB-IIP2) of +82 dBm at 1-GHz local oscillator (LO) frequency. In FD mode, the NF degradation is <= 1.5 dB. The effective IB-IIP3 and effective IB-IIP2 are enhanced by 15 dB and 28 dB, respectively. The power consumption of entire FD receiver including the SI canceller is less than 44 mW. The active chip area is 0.55 mm(2).

A CORDIC demodulator platform for digital-IF receiver

A 2-level FSK demodulator for digital-IF receiver

Design and Implementation of a 2-level FSK Digital Modems Using CORDIC Algorithm

The Design And Implement Of A Receiver For Fsk Signal

Design and Implementation of Micro-Satellite Receiver Using CORDIC Algorithm

An All-Digital Coherent-Like BFSK Demodulator

Digital Demodulator Design For Dvb-S2

Reconfigurable Digital Receiver for 8PSK Subcarrier Multiplexed and 16QAM Single Carrier Phase‐modulated Radio over Fiber Links

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A Low-Power All-Digital GFSK Demodulator with Robust Clock Data Recovery.

The Design and Hardware Implementation of OFDM System Receiver Based on FPGA

A 0.18 Um Cmos Reconfigurable Digital Baseband Transceiver With 2fsk For Rfid

Design of RFID Digital Receiver Based on FPGA

A Receiver Structure Of Joint Ldpc Decoding And Synchronization For Deep Space Communications

Digital implementation of FM demodulation based on the CORDIC algorithm with the expanded range of convergence

An All Digital Packet DS-CDMA Transceiver for HFC Network Upstream Transmission

Digital Correlation Demodulator Design for RFID Reader Receiver

A 0.2~3.8-Ghz Full-Duplex Receiver with More Than 25 Db Self-Interference Cancellation Using a C-DAC-Based Vector Canceller.

A low power self-sampling IF FSK receiver

Digital Realization of FM Demodulation Based on Cross Product Frequency Discriminator

Design of Novel Digital GFSK Modulation and Demodulation System for Short-Range Wireless Communication Application