Al-TiC in situ composite coating fabricated by low power pulsed laser cladding on AZ91D magnesium alloy
Liuqing Yang,Zhiyong Li,Yingqiao Zhang,Shouzheng Wei,Fuqiang Liu
DOI: https://doi.org/10.1016/j.apsusc.2017.11.240
IF: 6.7
2018-03-01
Applied Surface Science
Abstract:Al + (Ti + B4C) composite coating was cladded on AZ91D magnesium alloy by a low power pulsed Nd-YAG laser. The Ti+B4C mixed powder is with the ratio of Ti: B4C = 5:1, which was then mixed with Al powder by weight fraction of 10%, 15% and 20%, respectively. Scanning electron microscopy, energy dispersive spectrometer and X-ray diffraction were used to study the microstructure, chemical composition and phase composition of the coating. Results showed that the coating had satisfied metallurgical bonding with the magnesium substrate. Al3Mg2, Al12Mg17, Al3Ti and TiC were formed by in-situ reaction. The coatings have micro-hardness of 348HV, which is about 5–6 times higher than that of AZ91D. The wear resistance and corrosion resistance of the coatings are enhanced with the addition of the mixed powder.
chemistry, physical,physics, applied, condensed matter,materials science, coatings & films