Abstract:Journal of Low Frequency Noise, Vibration and Active Control, Ahead of Print. Most APFs use improved designs of active power filters of half-bridge and full-bridge circuits, their advantages and disadvantages are compared. International journals often use this filter circuit for small circuit boards. For large power systems, nonlinear loads still need to overcome harmonic pollution and magnetic pollution. Its disadvantage is that it will reduce the power of the system and requires power compensation. For nonlinear load harmonic filtering, RLC high-pass filter is not the best filtering method. Due to high-power rail high-voltage systems (22 KV–161 KV), the industry has not yet applied APF to remove harmonics. Previous research on nonlinear load harmonic filters for high-voltage systems was only 6.9 KV. Later, with the development of industry and the increase in electricity consumption, the high-voltage system increased to 22 KV–161 KV. Experimental data on high-voltage power systems are difficult to obtain. This study verified the feasibility of this method through simulation. Therefore, this study proposes to use a combination of two single-phase high-pass filters form a three-phase APF to filter nonlinear load harmonics in the track's large power system and effectively increase the capacity of the large power load. APF filters harmonics through three phases to prevent train signal abnormalities and extend the service life of trains. Since the centralized power supply system must be used in conjunction with other loads, harmonic pollution will occur. Electric vehicles accept this kind of pollution source, which is detrimental to on-board equipment and on-board signals. In power electronics theory, the spirit of this article is to use APF to filter out harmonics of the power system through three-phase technology in the range of 22 KV–161 KV. This has not yet been done in the industry. I put forward this theory, which is also the meaning of this job.

Research on Parallel Operation of Active Power Filters Applied to High-Voltage High-Power System

Research on Parallel Operation of Active Power Filters

Parallel Converter Scheme for Large Power High Compensation Precision Shunt Active Power Filters

High-Performance Resonant Controller For Active Power Filter With Selective Harmonic Compensation

Simulation of the Active Filter with a Multilevel NPC Inverter

Analysis on Converter Topology of Active Power Filters Applied to Middle Voltage and High Voltage System

Modeling and Design of the Output Filter Applied to High Power Shunt Active Power Filters

Research on Control System of DC Voltage for Active Power Filters with Three-Level NPC Inverter

Study on Shunt Active Power Filter with High Quality Grid Current Waveform

A Novel Active Power Filter for High Voltage Application

A Series Active Power Filter Adopting Hybrid Control Approach

Study on Large Power Shunt Active Power Filters with High Compensation Precision

Using special APF to improve harmonic rate of MRT power system

A Novel Voltage-Mode Control of Parallel Active Power Filter

Research on the Control Algorithm of DC Voltage for Active Filter with a Three-level NPC Inverter

Design and Implementation of a Three-Level Active Power Filter for Harmonic and Reactive Power Compensation

High precision compensation for high power Hybrid Active Power Filter based on repetitive control algorithm

Inverter-Less APF Based on Push-Pull Forward AC-AC Converter for VAR and Harmonic Compensation

Study on a transformerless Hybrid Active Power Filter with high compensation precision and dynamic performance

Status Quo of Research on Active Power Filters for Median and High Voltage Power Systems