Abstract:This paper proposes a new type of fabricated shear wall system, that is, the two ends of the horizontally distributed ribs and the top of the vertical distributed ribs are reliably connected with the cast-in-situ belt, and the bottom of the vertical distributed ribs is not penetrated and only connected by mortar. To study the seismic performance of the new wall, 7 specimens of the shear wall were designed and manufactured, including 2 cast-in-place shear walls and 5 new fabricated shear walls. Through low-cycle reciprocating loading tests, different analyses were made. Shear span ratio and different edge restraint structure of the new fabricated shear wall failure mode, bearing capacity and other seismic performance, and through OpenSees finite element analysis of the wall to verify the correctness of the modelling method. The test results show that the failure characteristics of the new wall are mainly the cracking and penetration of the mortar layer, the crushing of the corner concrete and the local buckling of the steel bars at the bottom of the edge members; compared with the cast-in-place wall, the new wall has the lower bearing capacity, but the deformation and energy consumption are not much different. The reinforced edge members can effectively compensate for the weakening of the integrity of the wall panel caused by the discontinuity of vertical steel bars. Among the 7 specimens, the overall performance of the wall with increased longitudinal reinforcement ratio is the best. The error between the wall finite element results and the test results is less than 5%, which shows that the modelling method in this paper has sufficient accuracy for the evaluation of the seismic performance of the new wall. In general, the new prefabricated shear wall system is feasible in high-rise buildings.

Experimental Investigations and Analysis of Shear Capacity of Masonry Walls with Window and Door Openings Reinforced with CFRP Sheets

Seismic Behavior of Composite Shear Walls Incorporating Concrete-Filled Steel and FRP Tubes As Boundary Elements

Experimental Study of Masonry Walls Strengthened with Cfrp

Experimental Study on Seismic Reinforced of Brick Masonry Walls with Carbon Fiber Reinforced Polymer (CFRP)

MECHANICAL BEHAVIOR OF MASONRY WALLS STRENGTHENED WITH CFRP

Experimental investigation on seismic behavior of S350 light-gauge composite framing walls

Experimental Study on the Seismic Performance of New Sandwich Masonry Walls

Numerical and Experimental Investigation on Cyclic Behavior of Masonry Infill Walls Retrofitted with CFRP

Seismic Performance of Multistorey Masonry Structure with Openings Repaired with CFRP Grid

Experimental and Numerical Study on the Seismic Performance of Prefabricated Reinforced Masonry Shear Walls

EXPERIMENTAL STUDY OF A MASONRY BUILDING RETROFITTED INTEGRALLY BY PRE-FABRICATED RC PANELS

Seismic Performance of SFRC Shear Walls with Window Opening and the Substitution Effect for Steel Bars

Experimental and Finite Element Analytical Investigation of Seismic Behavior of Full-Scale Masonry Infilled RC Frames

Experimental study on existing brick walls strengthened with high-strength steel wire mesh and polymer mortar

Experimental Analysis of Surface Application of Fiber-Reinforced Polymer Composite on Shear Behavior of Masonry Walls Made of Autoclaved Concrete Blocks

Experimental Investigation into the Seismic Performance of Prefabricated Reinforced Masonry Shear Walls with Vertical Joint Connections

Experimental study on seismic performance of new-type fabricated shear wall with mortar connection

Seismic Performance of Unreinforced Masonry Walls with Various Retrofitting Methods

Out-of-plane strengthening of URM walls using different fiber-reinforced materials

Experimental Investigation of Effect of Section Configuration on Seismic Performance of an Innovative Integrated Concrete Masonry Wall System

Experimental investigation on the size-dependent CFRP shear contribution in CFRP-strengthened RC shear wall