Abstract:There are three difficulties in the topology optimization problem of continuum structure:1) The problem under multiple load case is not easy to be approached than that under single load case, because the former becomes a multiple objective problem on the basis of compliance objective function. 2) The problem with local constraints, such as elemental stress limit, is not easy to be solved than that with global constraints, such as displacement or frequency limits, because sensitivity analysis of the former has too expensive computation. 3) The problem with a phenomenon of ill-conditioned load, which is similar to ill-conditioned stiffness matrix in the structural analysis, is not easy to get reasonable final topological structure, because the former is difficult to consider different influences between the loads with small forces and the loads with big forces, and some of topology paths of transferring small forces may disappear during the process of iteration. To overcome the above difficulties, some measures are adopted as follows:1) Topology optimization model is established by independent continuous mapping (ICM) method. 2) Based on the von Mises criteria in theory of elastic failure, all element’ s stress constraints are transformed into a structural energy constraint, namely, a global constraint substitutes for lots of local constraints. 3) The phenomenon of the ill-conditioned load is divided into three cases: (a) Ill-condition exists between load cases, but not within each load case; (b) Ill-condition exists within some load case; (c) Ill-condition exists not only between load cases, but also within some load case. (4) A strategy based on strain energy is proposed to adopt ICM method with stress globalization, and the problems of the three cases of ill-conditioned load mentioned above are solved in term of different complementary approaches one by one. Numerical examples show that the topology path of transferring forces can be obtained more easily by substituting global strain energy constraints for local stresses constraints, and the problem of ill-conditioned load can be solved well by the weighting method which takes structural energy as weighting coefficient.

TOPOLOGICAL OPTIMIZATION OF THE CONTINUUM STRUCTURE WITH NON-FREQUENCY-BAND CONSTRAINTS

TOPOLOGY OPTIMIZATION OF CONTINUUM STRUCTURE WITH FREQUENCY RESPONSE CONSTRAINTS

Topological Optimization of Continuum Structure with Static Displacement and Frequency Constraints by ICM Method

Topology Optimization of Tensegrity Structures Considering Buckling Constraints

Discrete variable topology optimization for maximizing single/multiple natural frequencies and frequency gaps considering the topological constraint

An improved multi-objective topology optimization approach for tensegrity structures:

Topology optimization of vibrating structures with frequency band constraints

TOPOLOGICAL OPTIMIZATION OF CONTINUUM STRUCTURE UNDER THE STRATEGY OF GLOBALIZATION OF STRESS CONSTRAINTS

A New Topology Optimization Methodology Based on Constraint Maximum-Weight Connected Graph Theorem

Maximization of Values of Simple and Multiple Eigenfrequencies of Continuum Structures Using Topology Optimization

2D Minimum Compliance Topology Optimization Based on a Region Partitioning Strategy

Topology optimization for cyclic periodic structures with frequency objectives of nodal diameter modes

Topology Optimization of Freely Vibrating Continuum Structures Based on Nonsmooth Optimization

Dynamic topology optimization for structures exhibiting frequency-dependent material properties with prescribed frequency forbidden band

A Multi-Objective Topology Optimization Methodology Based on Pareto Optimal Min-Cut

Topology Optimization of Continuum Structure With Globalization of Stress Constraints

Topology Optimization of Continua Considering Mass and Inertia Characteristics

Topology optimization of finite similar periodic continuum structures based on a density exponent interpolation model

Checkerboard Problem to Topology Optimization of Continuum Structures

TOPOLOGY OPTIMIZATION OF CONTINUUM STRUCTURES SUBJECTED TO SELF WEIGHT LOADS