A 1 V 0.18 Μm Fully Integrated Integer-N Frequency Synthesizer for 2.4 GHz Wireless Sensor Network Applications
Xiangning Fan,Li Tang,Yujie Wang,Lu Yu,Liang Yuan,Zehua Yang,Zhigong Wang
DOI: https://doi.org/10.1007/s10470-014-0459-x
IF: 1.321
2014-01-01
Analog Integrated Circuits and Signal Processing
Abstract:A 1 V low voltage, low power integer-N frequency synthesizer applied for 2.4 GHz wireless sensor network (WSN) applications is presented. The loop parameters of proposed charge pump phase lock loop frequency synthesizer is calculated and verified on the basis of continuous linear model. The proposed voltage controlled oscillator (VCO) consists of a PMOS cross-coupled transistor pair, a NMOS tail current source and a LC resonator. Common-mode 2nd harmonic filters are employed to improve loaded Q factor and suppress noise. LC resonator is optimized and switched capacitor array is used to lower AM–PM noise conversion. Fabricated in TSMC 0.18 μm CMOS process, the measured phase noise of VCO is −113.4 dBc/Hz@1 MHz, and −124.5 dBc/Hz@3.5 MHz while the frequency tuning range covers 4.56–5.32 GHz with 1 V voltage supply. The power dissipation is 2.3 mW and corresponding FOM is about −185 dBc/Hz. With other blocks of dividers, phase frequency detector, charge pump and auto frequency calibration, the die area of the whole fabricated frequency synthesizer is 1.33 mm2 with pads. With 1 V supply voltage and 9.1 mW power consumption, the measured phase noise of the frequency synthesizer is −121.9 dBc/Hz@1 MHz and −134.4 dBc/Hz@3.5 MHz respectively, and the reference spur is −44.5 dBc. The performance of the designed 1 V integer-N frequency synthesizer is suitable for IEEE 802.15.4/ZigBee based 2.4 GHz WSN applications.