Abstract:In this paper, signal descriptions and formulations for the radio frequency ( RF) front-end of a passive backscatter radio frequency identification ( RFID) reader working at ultra high frequencies ( UHF) are discussed in detail, and a set of design considerations aiming to improve the read range are outlined. The reader's architecture is proposed and the design details of its RF frond-end are presented. The read range is formulated through calculating the time-averaging power absorbed by the tag and the signal-noise-ratio ( SNR) of the demodulation, and accordingly RFID systems can be classified into tag-determining and reader-determining ones. It is concluded that the gain of the reader antenna, the phase noise of the local oscillation ( LO) and the receive-transmit isolation coefficient dominate the demodulation output noise of the reader, and consequently the reader-determining maximum operational distance. A prototype reader working at the frequency of 915MHz was built with off-the-shelf components and was evaluated with a commercial tag in an indoor environment. The measured results show that this RFID system is of tag-determining and has a read range of 8.4 meters, which are in good agreement with the calculated results.

Signal Analysis And Design Criteria For Uhf Rfid Reader

Signal Descriptions and Formulations for Long Range Uhf Rfid Readers

A System Design for the Reader of Microwave Radio Frequency Identification

Electromagnetic Environment of Uhf-Rfid

Design for the reader of UHF Radio frequency identification

The Design of the RF Front-End of Reader Based on SAW RFID

Design and implementation of a long-range RFID reader

A Design Scheme of Long-range Reader Based on IS018000-6B Protocol

A Novel Adaptive Leakage Suppression Method for UHF RFID Reader

Issues in Integrated Circuit Design for UHF RFID

An Optimization Method of Carrier Suppression for UHF RFID

The Design of a Portable UHF RFID Reader

Several Key Issues in Single-Chip UHF RFID Reader Design

Design of Digital Receiver for UHF RFID Reader

An On-Chip Configurable Receiver with >55-Db Tx Leakage Suppression for UHF RFID Reader

High TX-to-RX Isolation in UHF RFID Using Narrowband Leaking Carrier Canceller

Design and Implementation of a UHF Active RFID System

Channel arrangement in multi-reader RFID system

Radio link analysis and design of directional coupler with high isolation for UHF RFID reader

A High Linearity Low Noise Integrated UHF RFID Reader Receiver Front-end

Electromagnetic analysis and attacks system for cryptographic RFID