Abstract:Inversion of magnetotelluric (MT) responses has been used to explore the electrical conductivity distribution of the Earth's interior. In three-dimensional (3-D) inversions, it is significant to use a good initial model, because final model obtained by most 3-D inversion methods is influenced by the initial model. Although uniform initial models are widely used in 3-D inversions, one-dimensional (1-D) initial models are alternatives, which could more appropriately represent the actual conductivity variations in the Earth's interior. This study presents a two-step 3-D inversion method, especially for marine cases. This inversion method first concentrates on obtaining a 1-D initial model and then inverts for 3-D conductivity structures with it, in both of which the 3-D topography is carefully taken into consideration. This method was tested by synthetic models of different topography variations (depression-shaped, smoothly varying, channel-shaped and square-shaped plateau topography) and of heterogeneous layers with different checkerboard-type anomalies (sharp or smooth lateral conductivity variations) embedded in 1-D model of depth-dependent conductivity. The comparisons were done about obtaining an initial model by the proposed method and that inverted from the corrected responses. The results of 3-D inversions by using the method of this study were also compared to that with different uniform initial models. Results of synthetic tests and comparisons were discussed by using directional information of newly introduced model-vector parameters. The performance and validity of this method was verified. It also revealed that some of the newly introduced model-vector parameters could be used to show the convergence of inversions and help to select inverse model.

Pseudo-Three-Dimensional Magnetotelluric Inversion Using Nonlinear Conjugate Gradients

A FEASIBILITY STUDY OF RAPID TWO-DIMENSIONAL MT CURVE COMPARISON INVERSION

Gauss–Newton With Preconditioned Conjugate Gradient Magnetotelluric Inversion for 3-D Axial Anisotropic Conductivities

Three-Dimensional Magnetotelluic Parallel Inversion Algorithm Using Data Space Method

Three-Dimensional Magnetotelluric Inversion for Triaxial Anisotropic Medium in Data Space

Three-dimensional Magnetotelluric Inversion Based on Multigrid Algorithm

Three-dimensional magnetotelluric inversion under topographic relief based on the limited-memory quasi-Newton algorithm (L-BFGS)

3D magnetotelluric inversion using a limited-memory quasi-Newton optimization

Three-dimensional Regularized Inversion of Magnetotelluric Data with a Minimum Support Gradient Constraint

Three-dimensional finite-memory quasi-Newton inversion of the magnetotelluric based on unstructured grids

Sensitivity study on two-dimensional and three-dimensional magnetotelluric inversions

Three-dimensional magnetotelluric inversion using L-BFGS

A two-step three dimensional marine magnetotelluric inversion method with considering rugged seafloor topography: Synthetic studies

3-D Magnetotelluric Deep Learning Inversion Guided by Pseudo-Physical Information

A limited-memory quasi-Newton inversion for 1D magnetotellurics

Three‐dimensional Inversion of Full Magnetic Gradient Tensor Data Based on Hybrid Regularization Method

Three-dimensional joint inversion of gravity and magnetic data using Gramian constraints and Gauss-Newton method

3D Step-by-step Inversion Strategy for Audio Magnetotellurics Data Based on Unstructured Mesh

Appraisal of the Magnetotelluric and Magnetovariational Transfer Functions' Selection in a 3-D Inversion

An Alternating Direction Method of Multipliers Algorithm for 1-D Magnetotelluric Anisotropic Inversion Using Fourier Series Expansion

Three-Dimensional Conjugate Gradient Inversion of Csamt Data