Simulation Study of Body Surface ECG Based on a Dynamic Heart Model

XIA Ling,YE Xue-Song,HUO Mei-Mei,LIU Feng

DOI: https://doi.org/10.3969/j.issn.0258-8021.2006.03.001

2006-01-01

Abstract:Most previous electrical heart models were static, not beating ones. When computing body surface ECG based on quasi-static field theory, the distances between equivalent cardiac dipoles (source points) and body surface (field points) were supposed to be constant during the whole cardiac cycle. Large system errors could be introduced because of the significant relative position changes of source-field points during cardiac systole and diastole. Therefore, to improve the ECG simulation accuracy, a beating or dynamic heart model should be considered. In this investigation, a dynamic or beating heart model was constructed based on our previous static electrical heart model, and a comparative simulation study of 12-lead ECG based on dynamic and static heart models was presented. In the dynamic heart model, the coupling of electrical excitation and mechanical contraction were considered, and the resulted relative position changes between heart wall and body surface during cardiac systole and diastole were employed to calculate body surface ECG afterwards. The results showed that, compared with ECG signals simulated from the static electrical heart model, the ECG signals obtained from the beating heart model was more accordant with clinical recorded ECG, especially for ST segment and T wave of V1-V6 lead ECG. For slight-degree myocardial ischemia, the ST segment and T wave changes were observed from the simulated ECG based on beating heart model, while the ST segment and T wave of simulated ECG based on static heart model was almost unchanged compared with normal ECG. These simulation results suggest that the beating heart model generate more accurate ECG signals.