LARGE-SCALE SHAKING TABLE TEST AND ITS NUMERICAL SIMULATION OF RESEARCH ON BUILD-UP BEHAVIOUR OF SEISMICALLY-INDUCED PORE WATER PRESSURE IN LIQUEFIABLE SITE

LING Xianzhang,TANG Liang,YU Enqing
DOI: https://doi.org/10.3321/j.issn:1000-6915.2006.z2.104
2006-01-01
Abstract:Based on the effective stress principle and empirical mode of dynamic increase of pore water pressure,adopting computation method for increment of pore water pressure by stress cyclet,he numerical simulation model directly aiming at large-scale shaking table test of earthquake response of ground in non-free liquefaction site is established to numerically simulate and analyze the dynamic increase of the pore water pressure of ground.The result of numerical simulation indicates that,under the condition of El Centro earthquake ground motion with amplitudes of 0.15g and 0.50gt,he pore water pressure changes prominently before 13 si,ncreases instantaneously at 13 s,and reaches to a peak value at 25 s;and the pore water pressure ratio at the point of the peak value gradually augments from bottom to top.The sand layer in upper part gains the pore water pressure ratio of local liquefaction under the condition of El Centro earthquake ground motion with the amplitude of 0.15g and the entire sand layer all arrives at the pore water pressure ratio of full liquefaction under the condition of El Centro earthquake ground motion with the amplitude of 0.5g.Besides,it is shown that the pore water pressure in the area close to the pile is higher than that in the area far from the pile,and a certain gradients of pore water pressure appear around of the pile as a result of the dynamic interaction of pile-soil;and it is gained that the change regularity recorded in the shaking table test is almost consistent with that obtained from numerical simulation.In a word,this numerical simulation method for dynamic increase of pore water pressure basically reflects the dynamic increase course of the pore water pressure under the condition of strong earthquake ground motion,but the computing error by means of this method is rather obvious under the condition of weak earthquake ground motion.
What problem does this paper attempt to address?