Modeling and Application of Emission Threshold of Atmospheric Pollutant to Achieve the Standard

XU Wei-guo,ZHANG Qing-yu,WEI Yu-mei,DING Feng
DOI: https://doi.org/10.3321/j.issn:1008-9209.2006.06.017
2006-01-01
Abstract:Based on the improvement of grey clustering analysis method,a new methodology is presented for threshold calculation of single atmospheric pollutant emission to achieve the standard grade,which is the precondition of environmental management and decision-making and also is an important content of total amount control.each real emission value of pollutant factor is uniquely corresponding with a nonzero weight,while zero weight problems occur with the classical grey clustering analysis method.After comprehensive evaluation of atmospheric environmental quality,the emission threshold of single atmospheric pollutant can be calculated.If the comprehensive grade of atmospheric environmental quality is Ⅲ,which has been above the standard grade,the minimum cut threshold can be calculated to achieve the standard grade.On the other hand,with keeping the comprehensive grade in grade Ⅱ,the maximum control threshold can be given from the model if the present grade is Ⅱ.As an application,the emission threshold of single atmospheric pollutant was calculated in Hangzhou,2004.It is indicated that the present comprehensive grade was Ⅲ grade which was above the standard.If the comprehensive grade agreed with standard,the minimum cut threshold of emission concentrations of main atmospheric pollutants,SO_2,NO_2 and PM_(10),were 0.0390 mg·m~(-3),0.0410 mg·m~(-3) and 0.0912 mg·m~(-3),which mean their concentration must decrease more than 22.69%,27.62% and 21.58%,respectively.
What problem does this paper attempt to address?