Immersion Depth Optimization of Single Nozzle During Beam Blank Continuous Casting Based on Multiphysics Characteristics
Zhiqiang Peng,Zibing Hou,Ping Tang,Hao Li
DOI: https://doi.org/10.1007/s11663-024-03080-8
2024-04-10
Metallurgical Transactions B (Process Metallurgy)
Abstract:Longitudinal surface cracks are prevalent in the continuous casting of hypo-peritectic beam blanks, primarily related to multiphysics non-uniformity (multi-phase field, flow field, temperature field) within the mold. Therefore, multi-phase and coupled flow-thermal models were constructed to investigate the non-uniform multiphysics characteristics in the beam blank mold with a single nozzle and its effect on the formation of longitudinal cracks. First, the three-phase flow model reveals significant unevenness slag distribution along the web width, positively correlated to surface velocity of the molten steel. Subsequently, considering the impact of the solidification shell, surface velocity decreases nonlinearly with increasing immersion depth, influenced by web vortex position in the X-direction, which is also influenced by mold curvature, and interaction between web and side vortexes. Furthermore, the temperature field distribution inside the mold is non-uniform. Under the effect of the single-web recirculation flow, the temperature near the meniscus at the NN (position near the nozzle) side of the web is lower than that at the FN (position far away from the nozzle) side, resulting in more intensive initial cooling at this position. Meanwhile, a reheating zone exists at the mold exit of the NN side. Statistical analysis revealed that the absolute values of Spearman coefficient between the non-uniformity of shell thickness and the temperature and flow velocity of the molten steel exceed 0.6, which is related to the depth of the web vortex. Finally, from the perspective of the influence of SEN's immersion depth on multiphysics, the high surface velocity of the steel, strong cooling near the meniscus, and non-uniform shell thickness at the mold exit can be relieved with an immersion depth of 75 mm. The plant experiment confirmed that increasing the immersion depth from 65 to 75 mm leads to a relative reduction of 39 and 43 pct in the longitudinal cracks ratio for strands and rolled products, respectively.