Abstract:The converter controller model is the key part of a doubly-fed induction generator (DFIG) model.Because of the large number of controller parameters and the series connection between the PI controllers of inner and outer control loops,the traditional identification methods have some trouble with identifiability or engineering realization.A parameter identification method is proposed based on the disturbances made on the measurement signals of secondary side,which features multi-step identification and interactive iteration.The method separately makes disturbances on the measurement signals which are used as input of PI controllers in the converter control system.These disturbances can enlarge the effect of the triggered PI controller on the response of a DFIG.Therefore,parameters of the triggered PI controller can be identified by using its measurable control target as the observation.For the series connected PI controllers,the measurement signal disturbance will be made on the latter PI controller while shielding the change of the input measurement signal of the former PI controller. Thus,the decoupling identification can be carried out on the parameters of series connected PI controllers.Using the proposed method,the two parameters of each PI controller in the converter control system can be identified separately without any identifiability problem under the certain measurement signal disturbance.And the interactive iteration of identification can further improve the identification accuracy of total parameters.

On Line Parameter Identification of RL Circuits Excited by a Steady State Mixing Frequencies Supply

On-line Frequency Response Method of Synchronous Machine Parameter Identification Based on Rotor Angle Measurement

ON-LINE IDENTIFICATION OF POWER SYSTEM DYNAMIC EQUIVALENT Part Two Parameter Estimation & Simulation

Parameter Identification Method for Converter Controller of DFIG Based on Measurement Signal Disturbance

Parameter Identification of Phase-Locked Loop in DFIG-Based Wind Turbine

Online Parameter Identification for Surface-mounted Magnet Synchronous Motors Based on Adaptive RBF Neural Network

A Parameter Design Method of CLLC Resonant Converter Based On Time-Domain Model

Research on Parameter Identification of Buck Circuit

Parameters Estimation for Multiphase Induction Machine with Concentrated Windings Through Finite Element Method

Application Of Recursive Least Squares Method For Parameter Identification Of Deh Governing System

Recursive Least Square Method Based Parameter Identification of Steam Turbine Digital Electric-Hydraulic Governing System

Parameter Identification of Power Electronic Circuits Based on Hybrid Model

Parameter Identification of Induction Motors for Railway Traction Applications

Modeling and Parameter Identification of DC/DC Converters in Both CCM and DCM Mode

Parameter Identification Of Inverter-Fed Induction Motors: A Review

Parameter Observability Analysis of Interior Permanent Magnet Synchronous Motor and Online Parameter Identification Based on Adaptive Extended Kalman Filter

Online Identification of Inductance and Flux Linkage for SPMSMs Decoupled from Resistance Voltage Drop and VSI Nonlinearity

A technology for online parameter identification of permanent magnet synchronous motor

High Precision Off-line Parameters Identification of PMSM Considering Dead-time Effect

The Online Parameter Identification Method of Permanent Magnet Synchronous Machine under Low-Speed Region Considering the Inverter Nonlinearity

DC biased stimulation method for induction motor parameters identification at standstill without inverter nonlinearity compensation