Tribological Properties of Cu-Sn Alloy Against Steel Under Lubrication of Phosphonium Ionic Liquids

LIU Xu-qing,ZHOU Feng,LIANG Yong-min
DOI: https://doi.org/10.3321/j.issn:1004-0595.2006.01.008
2006-01-01
Abstract:Some ionic liquids of tributylalkyl phosphonium tetrafiuoroborate were prepared and characterized by 1H-NMR. Thermal stability was characterized by thermogravimetric analysis (TGA). Tribological properties of these phosphonium ionic liquids as a new kind of promising lubricant for a steel/Cu-Sn alloy contact, were investigated with an Optimal SRV friction and wear tester. As a comparison, phosphazene X-1P and L-P206, were also tested at the same conditions. Elemental composition and chemical nature of the boundary films generated on the worn surface were analyzed with a Kevex energy dispersive X-ray analyzer equipped on a scanning electron microscope, and an X-ray photoelectron spectroscope. As a result, the synthetic ionic liquids showed better friction-reduction and antiwear behavior than the L-P206 did. For applied load ranging from 100 N to 300 N, TPTB exhibited only 1/2 friction coefficient and 1/3 wear volume in comparison with L-P206.
What problem does this paper attempt to address?