Abstract:Monitoring traffic loads is vital for ensuring bridge safety and overload controlling. Bridge weigh-in-motion (BWIM) technology, which uses an instrumented bridge as a scale platform, has been proven as an efficient and durable vehicle weight identification method. However, there are still challenges with traditional BWIM methods in solving the inverse problem under certain circumstances, such as vehicles running at a non-constant speed, or multiple vehicle presence. For conventional BWIM systems, the velocity of a moving vehicle is usually assumed to be constant. Thus, the positions of loads, which are vital in the identification process, is predicted from the acquired speed and axle spacing by utilizing dedicated axle detectors (installed on the bridge surface or under the bridge soffit). In reality, vehicles may change speed. It is therefore difficult or even impossible for axle detectors to accurately monitor the true position of a moving vehicle. If this happens, the axle loads and bridge response cannot be properly matched, and remarkable errors can be induced to the influence line calibration process and the axle weight identification results. To overcome this problem, a new BWIM method was proposed in this study. This approach estimated the bridge influence line and axle weight by associating the bridge response and axle loads with their accurate positions. Binocular vision technology was used to continuously track the spatial position of the vehicle while it traveled over the bridge. Based on the obtained time–spatial information of the vehicle axles, the ordinate of influence line, axle load, and bridge response were correctly matched in the objective function of the BWIM algorithm. The influence line of the bridge, axle, and gross weight of the vehicle could then be reliably determined. Laboratory experiments were conducted to evaluate the performance of the proposed method. The negative effect of non-constant velocity on the identification result of traditional BWIM methods and the reason were also studied. Results showed that the proposed method predicted bridge influence line and vehicle weight with a much better accuracy than conventional methods under the considered adverse situations, and the stability of BWIM technique also was effectively improved. The proposed method provides a competitive alternative for future traffic load monitoring.

Identification of Vehicle Axle Loads Based on FEM-Wavelet-Galerkin Method

Wavelet domain analysis for identification of vehicle axles in the application of BWIM technology

A Numerical Method for Analyzing the Low-Frequency Noise of Bridge under Vehicle Load

Statistical Analysis of Site-specific Traffic Load Using Weigh-in-Motion Data

FE-based Bridge Weigh-in-motion Based on an Adaptive Augmented Kalman Filter

FEM analysis of vehicle-bridge vibration considering bridge deck's vibration

Identification method of vehicle parameters based on genetic algorithms

A computer vision-assisted method for identifying wheel loads of moving vehicles from dynamic bridge responses

A bridge dynamic response analysis and load recognition method using traffic imaging

Identification of the bridge moving loads based on fractional conjugate gradient method

Vehicle Loads Identification Through Vibration Monitor of Stay Cables

Identification of spatio‐temporal distribution of vehicle loads on long‐span bridges using computer vision technology

Static and dynamic vehicle load identification with lane detection from measured bridge acceleration and inclination responses

Deep learning-based identification of vehicular moving forces for bridges without axle configurations

Trajectory Tracking and Load Monitoring for Moving Vehicles on Bridge Based on Axle Position and Dual Camera Vision

A combined method for vehicle load identification based on machine vision and BP neural network

Structural damage identification based on dynamic deflection sensitivity of bridge under vehicle loading

BwimNet: A Novel Method for Identifying Moving Vehicles Utilizing a Modified Encoder-Decoder Architecture

Bridge influence surface identification method considering the spatial effect of vehicle load

Multi-lane vehicle load measurement using bending and shear strains

Time-domain identification of moving load on beam type bridges considering interval uncertainty in finite element model