Abstract:Nanocomposite particles of amorphous carbon-Li4Ti5O12 (C-LTO) and carbon nanotube-Li4Ti5O12 (CNT-LTO) were synthesized by solvothermal method and subsequent high-temperature calcination. X-ray diffraction (XRD), transmission electron microscopy (TEM), high-resolution transmission electron microscopy (HR-TEM), and selected area electron diffraction (SAED) were applied to characterize the phase structure, particle morphology, and the coating structure. XRD analysis, TEM micrographs, HR-TEM images and SAED analysis revealed that both LTO particles exhibited a well-developed spinel nanocrystal structure with average sizes between 20-70 nm. The C-LTO particles exhibited roughly spherical shape coated by an amorphous carbon layer up to 10 nm in thickness. The CNT-LTO samples showed uniform square nanocrystals with edge length around 20 nm and nanoscale graphitic layers covering the surface, revealing the carbon nanotubes interconnection networks among the particle assemblies. Electrochemical studies of lithium insertion/extraction performance are evaluated by the galvanostatic charge/discharge tests, cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). Both LTO particles showed the superior initial discharge capacity of more than 200 mAh/g at 1/10C rate. The irreversible capacity of the C-LTO particles at more cycles was due to large polarization resulted from excessive carbon and possible residual precursors. The CNT-LTO particles show larger reversible capacity and enhanced electrochemical Li+ insertion/extraction kinetics at different cycling rates. The comparative structural and electrochemical analyses demonstrated that both nanoscale graphitic covering layers and the CNT interconnection networks increase the electronic conductivity and improve the kinetics rates of lithium insertion/extraction in the CNT-LTO particles.

PREPARATION AND ELECTROCHEMICAL PROPERTIES OF NANOSTRUCTURED Li0.8CoO2

Cathode Materials of Li_xCo_(0.8)Ni_(0.2)O_2 for Lithium-ion Battery

Preparation and Electrochemical Properties of Li[Ni1/3Co1/3Mn1−x/3Zrx/3]O2 Cathode Materials for Li-ion Batteries

Microstructure and Electrochemical Characterization of Spherical-Like Orthorhombic LiMnO2 Via Co-Precipitation

Surface Structure Investigation of Lini0.8co0.2o2 by Alpo4 Coating and Using Functional Electrolyte

Structure and Electrochemical Properties of Spinel Li4ti5o12 Nanocomposites As Anode for Lithium-Ion Battery

Synthesis, Characterization And Electrochemical Properties Of Multi-Layered Porous Co3o4 Nanoparticle Assemblies

Structural and electrochemical characterization of nanocrystalline LI[Li0.12Ni0.32Mn(0.56)]O2 synthesized by a polymer-pyrolysis route

Study on the Structure and Electrochemical Characterization of the Non-stoichiometric Li1+xNi0.8Co0.2O2 Materials

Characteristics and properties of nano-LiCoO2 synthesized by pre-organized single source precursors: Li-ion diffusivity, electrochemistry and biological assessment

Preparation, characterization and electrochemical Li-absorption/extraction behaviors of nanosized Co-Sn intermetallic compounds

Preparation of Nano-Structured Lifexmn1-Xpo4 (X=0, 0.2, 0.4) by Reflux Method and Research on the Influences of Fe(Ii) Substitution

Nanostructure and its effect on electrochemical properties of polyanionic Li 2 CoSiO 4 for lithium ion batteries

Nanostructure and Its Effect on Electrochemical Properties of Polyanionic Li2CoSiO4 for Lithium Ion Batteries

Synthesis and microstructure characterization of Li[Ni1/3Mn1/3Co1/3]O2for lithium ion batteries cathode

Synthesis and Electrochemical Characterization of Li[Ni_xCo_(1-2x)Mn_x]O_2 Prepared by Spray Pyrolysis

Synthesis and characterization of LiCo1-xNixO2 nanoparticles by urea route as cathode for lithium-ion battery

Synthesis and Characterization of Ultrafine LiCoO2 Powders by a Spray-Drying Method

Study of Nanosized CoSb As Novel Anode Material of Li-ion Batteries

Synthesis and Electrochemical Properties of Sticktight-Like and Nanosheet Co3o4 Particles

Improvement of Electrochemical Performances of CoSb[sub 3] Anode by Using Nanosized Particles