Abstract:The low probability of single event upsets (SEU) within particular satellite orbits, makes Commercial-off-the-shelf (COTS) electronic components a viable solution for space system implementation, thanks to the introduction of design-level fault tolerance techniques at the expense of some performance/energy/area penalty. This paper illustrates the design and validation of a novel RISC-V dual-core architecture, based on a computing paradigm that we refer to as full/partial heterogeneous multi-core protection. The approach relies on a small, low-performance, fully fault-tolerant core (LP core) coupled with a high-performance partially fault-tolerant core (HP core). The computing paradigm assumes the failure-exposed HP core executes computation intensive routines for relatively short periods of time, making the occurrence of failures a statistically unlikely situation, while the fully fault-tolerant LP core operates in critical control tasks and manages the failure recovery of the high-performance core. The execution time percentage in the LP core varies from a minimum of 11.4% up to a maximum of 91.3% while in the HP core it is between 8.7% and 88.6%, depending on the application. In the proposed study, both the cores belong to the RISC-V compliant Klessydra core family. The dual-core architecture also includes a watchdog timer controlled by the LP core and monitoring the non-protected HP core, and a context switch FIFO that speeds up the code and data switch between the two cores during failure recovery. A dedicated run-time software environment coordinates the execution of tasks on the high-performance core in a resilient fashion. The dual-core processor has been validated through extensive RTL simulations running in an UVM-based fault-injection environment, which emulates SEUs at various rates. Experimental results illustrate the benefits and limits obtained by using a heterogeneous architecture with different levels of protection and performance. The failure probability assuming a SEU fault occurrence can be reduced by a factor between 10X and 30X with respect to the non-protected architecture, leading to an average failure rate of up to 4.00E-06 per second with respect to 1.80E-05 per second in the non-protected architecture.

High-Performance Fault-Tolerant Cordic Processor For Space Applications

Implementation of direct digital frequency synthesizer based on three-step rotation coordinate rotation digital computer algorithm

Fault Tolerant Computing for Stream Dsp Applications Using Gals Multi-Core Processors

Fault-Tolerant Nanoscale Processors on Semiconductor Nanowire Grids.

Bringing Fault-Tolerant GigaHertz-Computing to Space: A Multi-Stage Software-Side Fault-Tolerance Approach for Miniaturized Spacecraft

A RISC-V Fault-Tolerant Soft-Processor Based on Full/Partial Heterogeneous Dual-Core Protection

Eliminating Timing Errors Through Collaborative Design to Maximize the Throughput

A Fault-Tolerant Single-Chip Multiprocessor

FPGA IMPLEMENTATION OF AN FFT PROCESSOR USING CORDIC ALGORITHM

Design of COTS-based Fault-Tolerant Multiprocessor Real-Time Operating System

DuckCore: A Fault-Tolerant Processor Core Architecture Based on the RISC-V ISA

YHFT-QDSP: High-Performance Heterogeneous Multi-Core DSP

Dynamic Error Detection for Dependable Cache Coherency in Multicore Architectures

An Optimized Hardware Implementation of the CORDIC Algorithm.

Combining Circuit Level and System Level Techniques for Defect-Tolerant Nanoscale Architectures

Implementation of FPGA design of FFT architecture based on CORDIC algorithm

Wearout Tolerant Network Processing on Asymmetric Multi-core Processor

Design of a Reconfigurable Coprocessor for Double Precision Floating Point Matrix Algorithms

Fault Classification and Diagnosis Approach Using FFT-CNN for FPGA-Based CORDIC Processor

Design Of A Dynamic Reconfigurable Coprocessor For Flexible Precision Matrix Algorithms In Media Processing And Industrial Control Applications

Fault-tolerant Design Techniques in A CMP Architecture